Simulink, developed by MathWorks, is a commercial tool for modeling, simulating and analyzing multidomain dynamic systems. Its primary interface... | Contact experts in Simulink to get answers
1,588 views 1,576 posts
Questions related to Simulink
please provide the matlab simulink model and code of optimization with ITAE objective function
08 August 2019 5,847 4 View
I want to implement Simulink model as shown in attached figure. But the problem is how to get the DSK6713 which is shown in the right-south corner of the figure? Which software is required ? I...
08 August 2019 3,527 4 View
To design control algorithm for 3 phase inveter with unbalanced load using Cascade control (Voltage - outer, Current -inner). And also which safety protection must be carried out for testing in...
08 August 2019 1,842 5 View
simply, I can put a PI block in simulink and specify gain and sampling time .. BUT this time I need to remove this block from simulink and put a function block, where inside, I can set Kp .. Ki.....
08 August 2019 7,437 5 View
I want to limit the current entering the battery and a load. How can I use a current limiter in MATLAB Simulink?
08 August 2019 8,630 6 View
How can i generate a continuous signal from my discrete data vector in Simulink (with a Matlab function)? suppose that you have raw data from sensor...
08 August 2019 841 6 View
Derivative of state '1' in block xxxxx/STATCOM/Controller/LPF' at time 0.0 is not finite. The simulation will be stopped. There may be a singularity in the solution. If not, try reducing the step...
08 August 2019 6,091 2 View
hello all, In Simulink : how can I create a single pulse of: amplitude = 1, width = 300 sec (for example) when ever the input changes from 0 to 1 (otherwise it equals 0) ? thanks
08 August 2019 7,460 4 View
I am doing an analysis on MPPT in PV by comparing the traditional method with an intelligent one. I am looking for a working circuit ( PV with Fuzzy control ) with FIS matrix files. which i can...
08 August 2019 631 6 View
04 August 2019 3,879 3 View
I need to connect multiple wind turbines with generators by using MTDC (Multi Terminal Direct Current) and require generating output voltage of 9.9 kV. Please guide me in this regard. Thankyou.
07 July 2019 4,494 2 View
I want to know the electrical model of a fuel cell (PEMFC) in static and dynamic operating conditions to make simulations on Simulink. Thanks in advance for your answers !
07 July 2019 1,105 1 View
I have simulation data of sprung mass acceleration (A) vs time (t) in vertical direction for quarter car model. The data is taken as output from “to workspace” block of Simulink. I want to convert...
07 July 2019 5,511 9 View
I want to simulate laser diode in MATLAB simulink environment. I don't know where to start and i am new with laser so anyone please tell me how can I simulate it? What I have to learn before...
07 July 2019 1,025 0 View
I have inverter and I need to use MPC to select an appropriate input "u" to be applied at specific time from a series of input u. how I can do it in code of MPC ? for example, u = 000 010...
07 July 2019 1,482 3 View
I want start to work with Smart Grid Applications, How can start small example from demos?
07 July 2019 1,028 3 View
Dear Researches what is the name of this switch for arrow mark in simulation ckt in matlab(2013a) Simulink ?? Thanks in advance
07 July 2019 5,749 5 View
I'm trying to establish bidirectional communication between Simulink and Java (ultimately, a JAVE-based multi-agent system) using UDP. However, I keep getting Java timeout exceptions and can't...
07 July 2019 3,779 1 View
Hi everyone,I want to design a motor(transfer function) which opens in 4 and 10 seconds.I have transfer function which is 5/(s^2+18*s+1).My supervisor said me firstly you should transform step...
07 July 2019 5,412 11 View
Hi everyone,I m struggle to design a motor in Simulink.I have transfer fumction(motor).My supervisor said me that I should open this motor in 4 or 10 seconds according to input.Also my speed of...
07 July 2019 6,042 4 View
I need an appropriate state space model of Active power filter which I can implement on Simulink, I found many of them but not well emphasizing .. so if there is a Discrete state space model which...
20 June 2019 1,811 3 View
There is a leakage transformer (attachment 12) in a switching power supply based on resonance phenomenon. I performed some tests for finding the circuit modeling of the transformer and the...
06 June 2019 5,823 3 View
my whole simulation which contains the inverter on Simulink is discrete time system with discrete block 2e-6 sec I made a state space model for the inverter system Xdot=Ax+Bu but I guess that I...
06 June 2019 6,143 5 View
Not step disturbance but disturbance of rigid robot link weight in the form of transfer function which affect the movement and torque of motors. before or after plant transfer function?
06 June 2019 1,459 3 View