Simulink, developed by MathWorks, is a commercial tool for modeling, simulating and analyzing multidomain dynamic systems. Its primary interface... | Contact experts in Simulink to get answers
1,342 views 1,458 posts
Questions related to Simulink
I am running a comparitively large simulation, with sampling time of 1e-6s. I am not logging any data, however using many scopes. Although simultion completes 100%, however, while "Terminating"...
17 March 2021 1,367 4 View
In replacement of Simulink.
08 March 2021 3,906 28 View
Dear Professors, Colleagues and Friends I need to develop a simple Matlab/Simulink model of reverse droop controller for a simple LV MG. How can I get a simple one to use it as a sample? A basic...
23 February 2021 8,869 2 View
I am doing a project with PV array in Simulink. When I run small section of the total system i do not get an error. But when i integrate full system(my system model`s are completely okay) I get an...
19 January 2021 1,132 10 View
How to build aero engine fuel system online prognostics simulation model using Matlab, Simulink and Simscape?
18 January 2021 5,349 1 View
I am designing a control system for Hybrid renewable energy systems using Matlab/simulink/simscape, but currently having a problem. Whenever I run the simulation, I get the error shown below. "The...
13 January 2021 2,404 5 View
I am doing my research on a communication system. I need a Simulink model with MIMO OFDM anyone of you could suggest me to find the total OFDM transmitter and OFDM receiver Simulink design model
22 December 2020 3,828 1 View
Please I have 4 groups of 8 sets of differential equations that I want to use for simulations. Each set has 8 differential equations to form a group. Each group is coupled with another group...
15 December 2020 8,390 10 View
Hi everyone iam facing a problem to give control signal for switches in design of PSFB converter in matlab simulink. Anybody's help will be appreciated.
15 December 2020 6,184 3 View
I have created a three-phase cascaded h-bridge inverter at Simulink with the SHE-PWM technique, and I want to test it in the DVR applications. How can I design a controller for that in the DVR...
14 December 2020 873 3 View
Hello everyone, I am trying to generate a faulty acceleration signal with SIMULINK. The inner ring of the bearing is fixed to the shaft. The bearing has 17 rolling elements. I was thinking of...
11 December 2020 4,208 4 View
Hello ! When tried to linearize the model for Bode plot in matlab getting the following error. In "frestimate(modelname,op,io,in)", it is required for each of the linearization input I/O...
09 December 2020 4,819 1 View
Hello everyone, I am trying to implement an algorithm to detect possible damage at a bearing. In order to test my algorithm, it would be helpful to generate faulty bearing acceleration signals?...
08 December 2020 1,554 3 View
How to calculate the inductance and resistance of a 'multi-winding transformer MATLAB/Simulink block'?
08 December 2020 8,368 3 View
I have noticed my battery SOC keep on increasing even before I close the switch between Constant current source and battery ! Any idea why this is happening ? Tried manually deleting the...
04 November 2020 9,409 9 View
I am working with a paper which have to renewable resource system PV and Flywheel (FESS). The system is built with MATLAB software, for PV system has been done with good results, but I am facing a...
31 October 2020 4,299 2 View
Hello dear colleagues and experts! When developing a model of a wind generator, I faced the problem of adjusting the PI controller for the pitch angle. I read a lot of articles, but the PI...
28 October 2020 9,442 10 View
Hi all I have been simulating a WPT system to check the S-parameters and efficiency of my selected parameters (L, R, k, M) on ADS. Now I would really like to do the simulation on Simulink to...
27 October 2020 6,231 5 View
Dear all, I have a set of I/O data. I estimated a transfer function based ( command: tfest) on this data in MATLAB. (I removed the trend from the data before it: command: detrend). Can I...
25 October 2020 1,825 5 View
Dealing with LLC resonant converter simulation and would like to plot the efficiency curve. How Can I do that ? eff = Pout/Pin ( Pout I can calculate from Output voltage and current but input...
19 October 2020 5,376 4 View
Hi everybody, I'm doing a project for my BoS thesis in Electronics Engineering. What I have to do is to control a quadcopter (of which I have the mathematical model, both linearized and non...
19 October 2020 8,659 6 View
to design massive MIMO with 64 antennas in transmitter side
13 October 2020 8,514 2 View
I have gone through some papers related to DTC for five phase induction motor. And trying to simulate the circuit with their specifications using Matlab/Simulink. But got stuck with feedback...
08 October 2020 1,207 2 View
I want to model, simulate and study the partial shading effects on the electrical characteristics of Series-Parallel, Brindge-Linked, Honey-Comb and Total-Cross-Tied PV array configurations under...
06 October 2020 6,881 0 View