Simulink, developed by MathWorks, is a commercial tool for modeling, simulating and analyzing multidomain dynamic systems. Its primary interface... | Contact experts in Simulink to get answers
1,595 views 1,576 posts
Questions related to Simulink
I am implementing a solar array model on simulink and now I am facing an error on changing the open circuit voltage and short cicuit current."Steady state solve failed to converge". The diagnostic...
04 April 2019 4,205 2 View
An error occurred while running the simulation and the simulation was terminatedCaused by: Derivative of state '1' in block 'dof/Integrator6' at time 0.0058699478580727573 is not finite. The...
04 April 2019 4,302 3 View
Hello, as you would know, the formula angular frequency is w(t)=2*pi*fr(t)*t, where the t is the time and fr(t) is the frequency in the time. So my question is how in simulink can you put that...
04 April 2019 9,666 4 View
I'm currently using the PV arrays from Simulink (2016a) library to simulate a basic extremum seeking algorithm.The system is easily consist of a PV array, a DC-DC booster and a load. How can i...
04 April 2019 7,023 2 View
hello everyone hope anybody can answer my question please suppose I have two inputs and or three and the range of each input from 0-1 after scaling. I want to make membership function for the...
04 April 2019 8,072 2 View
I want to extract data from object detection sensor in Matlab 2018 (Mobile Robotics Simulation Toolbox). This data is the display vector array form of dimension (1x3) range; angle and label. I...
04 April 2019 5,753 4 View
Hello ALL I am currently working on a model where some subsystem need to be in continious and some need to be discrete mode. Is there any possibilty to run the complete system where some subsystem...
04 April 2019 1,375 4 View
root locus control system PID Fuzzy PID Stability analysis
04 April 2019 3,354 6 View
Simulink model of csp
04 April 2019 8,608 3 View
I want to plot MSE vs SNR using linear model in estimation theory. I can use matlab code or matlab simulink.
04 April 2019 3,693 4 View
Hello All, I am trying to test the performance of a motor(CMP80M - Sew Eurodrive - PMSM) as a generator in case of a Wind Turbine system. I have already implemented the dq equations of a PMSG for...
04 April 2019 9,700 1 View
I wanna Simulink Model in detailed for Incremental Conductance MPPT Algorithm for Single Phase Standalone PV system.
23 March 2019 7,355 3 View
Hello everyone, How to design VCO (Voltage controlled oscillator) for half bridge LLC resonant converter? if someone have any matlab simulink model including guideline that how i can set the...
21 March 2019 10,009 2 View
I want to ask how to integrate DSP controller Hardware in Simulink , how to design and how to work on it Please provide some technical details from starting, in real time matlab simulink design...
19 March 2019 1,164 6 View
Data Set Out table line 21, in the X-Plane Flight Simulator, Vx,Vy and Vz velocities are shown. And, these velocities are given at inertial frame, but i want to take body frame linear velocities.
06 March 2019 789 2 View
Currently i am doing project on optimal placement of dg using pso to reduce losses.
06 March 2019 2,692 2 View
Details ADRC (Active disturbance rejection control)_ESO (Extended state observer) matlab file
03 March 2019 8,399 2 View
In a Simulink/MATLAB simulation, i used the FFT Tool in the POWERGUI block to analyse a recorded signal 'sig', and at the same time i've coded a my own fft analysis function. Both methods gives me...
03 March 2019 4,342 5 View
I want to design gas-based a cooling system. For this purpose, I need to compare the performance of a fan and a compressor in circulating the gas inside a closed loop system. I started with...
03 March 2019 4,510 3 View
03 March 2019 5,963 3 View
How can i add Renewable generation in a Grid using Matlab simulink
03 March 2019 9,339 4 View
03 March 2019 9,748 2 View
I modeled a PV panel (Voc = 37.7V and Isc = 8.72A) in simulink with Rs and Rsh being dynamic. I tried to use it with a buck converter and a resistive load. The controlled current source cannot...
03 March 2019 6,962 6 View
03 March 2019 9,479 13 View