Simulink, developed by MathWorks, is a commercial tool for modeling, simulating and analyzing multidomain dynamic systems. Its primary interface... | Contact experts in Simulink to get answers
1,340 views 1,458 posts
Questions related to Simulink
Everyone knows matlab simulink, modelica and so on for simulation calculations. I want to make stand-alone app for kids with visual programming interface dor simulation different process and...
03 October 2020 3,594 3 View
I want to set the threshold of motor current. When the motor current reached to the limit, I want to control motor to rotate in other direction. I have to do this in Matlab Simulink. If anyone...
27 September 2020 1,646 2 View
I am working on a closed-loop system which has a PI controller. I have made a Simulink environment for the overall scenario but now I want to optimize the coefficients of the PI controller through...
24 September 2020 6,429 5 View
I want to implement below mentioned look up table in matlab simulink but i got error mentioning that ," Unable to perform assignment because the size of the left side is 2-by-3 and the size of the...
24 September 2020 9,605 3 View
Hi there, I'm trying to optimize an electric vehicle e structure (battery, motor, etc....), my battery model is on Simulink and the motor's is built using Ansys Maxwell I want to parallel optimize...
21 September 2020 3,479 4 View
I have a Simulink model and C code for a project. I need to cross verify by transforming c code to Simulink model. Can it be possible in Matlab or any other Source for the same.And too i tried...
09 September 2020 7,990 2 View
Hello everyone,recently I have met some problems in my study.I want to achieve a multi-agent system in DC micro-grids,but I never used java so that I can't use Jade to achieve it. Can I only use...
08 September 2020 6,460 2 View
I am performing an optimization, where in a Simulink Model (involving Matlab function blocks and discrete event blocks amongst other typical blocks) block parameters are changes by an optimization...
18 August 2020 5,034 4 View
I have trained a fully connected model with two layers using pytorch framework, I would like to use the trained model in Matlab for possible deployment in target hardware.
10 August 2020 6,989 3 View
Dear All when simulating a feedback control system with Fuzzy controller in MATLAB Simulink for a tank level get this warning in run mode : ''input 2 expects a value in range [-4 4], but has a...
09 August 2020 4,713 8 View
I was trying to realize the simulation of the paper, namely Adaptive Synchronization of Reaction-Diffusion Neural Networks and Its Application. I used Simulink for simulation, but the...
06 August 2020 8,622 1 View
I am simulating PV behavior on Simulink under various shading conditions using the KYOCERA KC200GT PV module with dimensions 56.2 in. * 39.0 in. If I have a 5x5 PV array with uniform...
04 August 2020 2,175 4 View
Any recommended URL or idea , that explains how to read encoder via Arduino IDE and then use these readings in MATLAB simulation to be used as a feedback compared with the desired speed and...
27 July 2020 8,615 7 View
I am trying to make a Matlab/Simulink model of Mach-Zehnder EOM but I won't able to add a laser source in it and how to apply electrical data in terms of half-wave voltage to the one arm of EOM?
07 July 2020 1,740 17 View
How can we make the rating of a battery in MATLAB/Simulink to Amp-sec instead of Amp-hour? I have tried with reducing the factor of 3600 to 1 inside the battery block. Is this approach completely...
04 July 2020 4,180 4 View
Hi, I'm new to the Simulink and wondering if there is an existing model I can use to simulate the relation among input variables (like inlet air temperature\pressure\humidity), compressor speed,...
16 June 2020 5,538 3 View
Recently, I began to study the multi-agent control of dc microgrid based on distributed consensus algorithm.I try to use the Jade platform to communicate between agents in the system, which can...
16 June 2020 4,564 7 View
I'm trying to do some searches about islanding detection of synchronous generators connected on distribution lines. I would like to know if anybody could help me with some paper that shows how to...
14 June 2020 5,516 7 View
I'm trying to run a Simulink model and at the same time receiving and processing data in a Matlab script, and sending the result into Simulink to change the behavior of the model. Is there any way...
04 June 2020 9,908 10 View
I've got Solar irradiance data and Temperature data for a month in 1 hour time intervals in a Excel sheet. I've modelled a Simulink block set to get the Output of a PV array. Unfortunately, I'm...
28 May 2020 3,224 5 View
Hi, i need a Matlab simulink model for PSO-fuzzy to track the maximum power point for a solar system Thank you [email protected]
22 May 2020 5,154 3 View
I have used hilbert filter on the current signal and i have to add two signals, one signal after hilbert filter and other signal before hilbert signal, however, i have used simple adder but i...
14 May 2020 7,552 7 View
Please recommend a tutorial set(pdf/book) for MATLAB Simulink for beginners?
09 May 2020 5,247 40 View
for example: for over head lines we can use pi section line or distributed paramters.I am working on the underground cable and in my system i want to add underground cable to get accurate results....
04 May 2020 3,370 3 View