Hello,
In order to prepare the Bromophenol blue for 6X loading buffer for protein. Do you use ethanol to dissolve Bromophenol blue or PBS buffer.
I made with ethanol but my gel bands started to look bad
Any Suggestion?
What method can you use to measure protein synthesis(translation) of specific protein in cell culture as an alternative to radio-labeled Methionine? Thank you
31 December 2018 4,075 3 View
The tumour microenviroment is very complex and composed from many bio-factors such as (EGFR, VEGF, chemokines, leuckocytes infilitrations...etc). I did many investigations on couple of tumour...
11 December 2018 579 0 View
Despite the limited motion, but I think in cases of crowded teeth or lateral interferences, these may result in future occlussion problems.
10 November 2018 7,453 5 View
Hi, Any suggestion for proteasomal inhibitor that blocks caspase-like activity of the proteasome in mammalian cells? MG132 and Bortezomib both acts on ChT-like acitvity! Thanx
06 November 2018 7,205 1 View
Hi, How long I need to starve MDA-MB-231 cells in serum free media to synchronize them before I infect them with my protein of interest using Adenovirus.. I'm aiming at conducting cell cycle...
22 December 2017 3,086 3 View
Hello, What are the limitations and pitfalls of using luceiferase expressing cancer cells injected in Xenographt mice for studying the metastasis? Thank you
18 November 2017 7,480 2 View
Hi, How do you normalize your cell numbers in viability assay to the zero hour reading if we start with different number of cells, because after seeding cells in 96 hr, there are different cell...
08 September 2017 7,908 3 View
Hi Anybody was able to use siRNA to block STAT3 alpha specifically? Thanx
16 July 2017 2,045 1 View
06 July 2017 9,306 1 View
Hi, I'm wondering what passage number is acceptable for MDA-MB-231 cells, Some labs kill these cells when they are 20-25 passages. Others Suggest it should be below 60 passages Thanks
06 July 2017 8,649 4 View
I got these smeared bands quite often lately. We typically run the gel at 140V with a 10-12% gel and do a wet transfer at 220 mA for 1.5 hr in cold room. We also noticed some dirty spots/dots (see...
10 August 2024 7,480 3 View
Does anyone tried to do nucleofection with AMAXA by Lonza with lower than recommended amount of buffer in the cuvettes (100 ul)?
07 August 2024 4,616 0 View
Currently, when I run SDS-PAGE, I don't see any bands at all, even though I used the same material just a day ago and it worked fine.... In our lab, we dilute the 10X running buffer to 1X and...
06 August 2024 5,373 2 View
I have been working on Red blood cell-derived extracellular vesicles as Antisense Oligonucleotide (ASO) carriers. We normally run agarose gel to quantify the loading efficiency. I used naked ASO...
06 August 2024 3,130 2 View
Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...
05 August 2024 3,783 2 View
I am having an issue with my gel image where my PCR product is not appearing very bright on the gel. When I perform gel extraction, the A260/280 purity value is very low. I used the Qiagen gel...
05 August 2024 9,798 3 View
Is it the "elution buffer" or the "dialysis buffer"? Note: I'll be using NanoDrop OneC
01 August 2024 967 3 View
99% pure ethanol was used for maceration also alternate methods along with the temperature and time to concentrate the extract can be specified
31 July 2024 5,113 4 View
Hello everyone, I performed a PCR yesterday, and the results showed no bands on the gel. Of course, I probably missed some crucial steps, like adding my samples to the PCR strips themselves, for...
31 July 2024 2,406 6 View
We are working on biopolymeric hydrogels. Our system is highly viscous and sticky, and the gel formed are high in strength. We are unable to use pH electrode and pH strip. Please suggest an easy...
30 July 2024 942 2 View