What is possible cell culturing application for laser induced periodic surface structure on polymer?

07 July 2016 1 6K Report

laser induced periodic surface structure for cell culturing

Neuronal stem cell differentiation. A number of articles show that stem cells will develop neuronal cell qualities when grown on the groves of compact disks. One place to start is this publication: Microgrooved Surface Modulates Neuron Differentiation in Human Embryonic Stem Cells.

http://www.ncbi.nlm.nih.gov/pubmed/24859927

Badges
Science topic

More Rana Taha's questions See All

Can any one help me to get melting and boiling temperature of cr 39 polymer?

i need to simulate laser ablation of Allyl digycol carbonate (ADC) or cr39 and in order to do that i need boiling and melting temperature of that polymer Thsnk you

11 December 2016 1,198 0 View

How i can calculate deposition coverage area if i have deposition diameter?

If i deposit a layer of thiophenol on a gold surface,how i can calculate average coverage area if i get a circle deposit layer and i measured its radius

10 November 2016 8,095 3 View

Where i can find raman spectrometer in tehran universities ?

In any university in tehran , can i find a raman spectrometer?

07 August 2016 3,169 0 View

Can i simulate surface enhancement raman scattering using ansys and if it is possible?

sers in ansys

09 October 2015 1,320 0 View

By using ansys,i simulated a grooves on a dielectric surface,how i can calculate surface roughness using ansys ?

how i can calculate surface roughness using ansys?

08 September 2015 6,301 1 View

By using ansys, how i can model laser heat source??

By using ansys,How i can model laser heat source??

06 July 2015 10,009 0 View

How i can simulate laser ablation by comsol multiphysics?

how i can simulate femtosecond laser ablation on a dielectric substrate using comsol multiphysics

04 May 2015 6,824 1 View

Can I simulate surface enhanced raman scattering using ANSYS multiphysics?

Regarding sers biosensor, can I simulate it in ANSYS?

04 May 2015 6,143 1 View

Can i simulate surface enhancement raman scattering by comsol multiphysics?

sers layer over a dielectric surface in order to get a biosensor

03 April 2015 8,367 1 View

Using OBD technique i am trying to measure laser induced shockwaves velocity i found that at start velocity increases and then decay?

i am unable to interpret why its increases in start as shown in figure

11 August 2024 2,179 1 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

Why Do TDS and EC Increase with Larger Wastewater Volumes, While BOD and COD Decrease?

I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...

09 August 2024 9,621 0 View

Hello researchers Is this a random laser or just fluorescence?

I am using Rhodamine6G as gain medium and silver nanoparticles as scatterers on a microscope slide and laser input 532 nm comes from above.

09 August 2024 9,894 2 View

Could it be a cell culture contamination?

Hello everyone! I observed in my culture (htert-RPE1 cells) an orange- red particle at the bottom of the dish. It is visible to the naked eye as a very very small red dot. Could it be a...

09 August 2024 2,824 3 View

Is there any way to quantify bacterial and fungal cells in their mixed culture?

I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...

07 August 2024 7,535 4 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

Why activated CAR-Jurkat cell could not kill targets?

Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...

06 August 2024 641 2 View

Could dyes amplify the spectrum of light to a specific wavelength?

I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...

05 August 2024 3,290 1 View

How to isolate lymphocytes from mouse spleen?

I have tried several times to isolate lymphocytes from mouse spleen, but all attempts have been unsuccessful. I tried most available protocols. I used different dissociation media (HBSS with Ca...

04 August 2024 9,913 7 View