i used 10 microliter ethidium bromide for each loaded samples(two) on slide(i.e 20 microliter for each slide) but under the fleurosent microscope, can hardly see the halo DNA or comet.
One of the captured photos is attached.
Please see.
این عکس با بزرگنمایی100 گرفته شده
به نظر شما چه مشکلی وجود داره
تاحدی که من این تصاویر را فقط می تونم توی بعضی لام ها ببینم و برخی از لام ها همین تصویر را هم ندارن
Hi.
It depends on the concentration of your EtBr Stock solution. If it wasn't high enough, then it might not be visible.
Conversely, if it was too concentrated, the cells might be overstained..
However, from the picture you sent, it seems that the concentration wasn't too strong. 10ul is okay per window. Try a slightly higher conc.
Also, confirm that the gels are actually on the slide because it might be that there is no gel there.
In addition, it could also be that there are no cells on the gel. You should try and confirm all of these.
All the best.
hi temitope.
steps my work in the process of cell suspension:
1- after the exit microtube(from freezer -80C) containing liver tissues and PBS buffer, Samples are placed on ice until the ice melted
2- then samples transfer into fresh microtube and Added 200 microliter PBS and We started to cut and homogenized tissues by scissors.
3- after the homogenization, samples are vortexed once and put on ice(Due to the large pieces are deposited).
4- After a few minutes, supernatant is removed with microsampler and transfered to new microtube
5- centrifuging with 1170 rpm,7 minute at 4 C
6- removing supernatant and added 100 microliters PBS and vortexed once
7- again removed the supernatant and added 10 microliter PBS and 100 microliter low melting point agarose
8- finally, after the few times Pipetting, solution loaded on slides and covered by coverslips
Do you confirm the above steps?
04 May 2015 4,475 4 View
04 May 2015 5,364 7 View
i.e. Instead of using the big and mature fish, small and immature fish such as juvenile and fingerling used
01 February 2015 1,348 11 View
Micronucleus assay to be carried out on fish. I am attaching several images, Please tell us your opinion.
31 December 2014 5,360 5 View
Recently I have captured new images with fluorescent microscope. I attached several images, can you comment on these?
31 December 2014 1,823 11 View
i want cutting the gill and liver tissue of fish
31 December 2014 5,637 13 View
in fact I want using gill and liver cells.
31 December 2014 2,259 2 View
these fish are not mature and me want to separation it for propagation
31 December 2014 8,468 3 View
if possible, attaching a file for this method please.
31 December 2014 1,782 3 View
i want expose toxicant substances on fish red blood cells.
11 December 2014 3,223 2 View
Hi, I have problems with running gel electrophoresis. I have tried agarose gel electrophoresis and native PAGE. I have two proteins, which have molecular weights of ~30kDa and ~180kDa and two...
03 March 2021 4,275 4 View
I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance
03 March 2021 3,568 1 View
Need to image mesoporous silica nanoparticles using the TEM. Also, need high resolution TEM images to see the mesoporous structure. Kindly suggest what kind of grids to use. Thanks, Shatadru
02 March 2021 1,787 2 View
Gel electrophoresis, RNA degradation, RNA extraction from fresh tissue
02 March 2021 5,433 5 View
Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !
02 March 2021 5,785 3 View
I'd like to perform single-strand conformation polymorphism (SSCP) in my thesis, however I cannot control the temperature of the vertical PAGE since we are using the conventional tanks. Is there a...
02 March 2021 9,157 1 View
Hello everyone, I had run a mediation model in SmartPLS using questionnaires that were already validated among my statistical population. A professor who edited my paper -though she is not...
01 March 2021 3,052 3 View
I am going to have 3 different probes in my qPCR work that I am going to do. But I realized that the machine we have in the lab is a Rotor-Gene Q 2plex HRM Platform, saying it has green, yellow,...
01 March 2021 8,544 1 View
Can someone please give me some possible things that could go wrong? Here is my recipe: 0.5g Agarose 50 mL of TAE 1x 1 uL ethyl bromide. Gel was run at 100V for 1 hour. The buffer used is also TAE.
01 March 2021 9,952 3 View
We are preparing some experiments based on irradiating cells under different conditions in order to evaluate the effects in terms of DNA damage, genetic expression, etc. As our project is...
01 March 2021 3,355 3 View