I am trying to encapsulate a protein hydrolysis using PLGA. the protein loading is very low. if you have an advice, please, share it.
Dear professors, I am going to manufacture mozarella cheese with direct acidification method using Acetic acid. what is the best concentration of acetic acid? is there any preferd conditions...
09 October 2017 1,852 0 View
Dear professors, I have an extract from moringa leaves. it is extracted with solvents. my question is how to dissolve this extract in a good way?
08 September 2017 8,705 5 View
I am looking for the right source to get the equations of Anova by Spss, if you know the right source, please refer it to me.
31 December 2015 4,381 2 View
what is the justification of using 26s primer for identifying yeast?.
09 October 2015 3,192 1 View
I need to understand the mode of action of captopril as a drug for hypertension
09 October 2015 147 2 View
If you have encapsulated peptides in cyclodextrin and would like to extract these peptides from encapsulation statue, what is the method for this?
03 April 2015 1,755 5 View
02 March 2015 6,491 12 View
i need to know the fluorescence spectrum of histidine-leucine peptide and for histidine and leucine amino acids
01 February 2015 3,569 3 View
What is the best wave length for measuring the absorbance of peptides during HPLC run?
11 December 2014 8,004 14 View
See above
11 December 2014 5,250 5 View
I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance
03 March 2021 3,568 1 View
I am a little confuse with the mechanism of solid lipid nanoparticles (SLNs). The main point of encapsulating drugs into SLNs is because some drugs have low solubility in water. Therefore, SLNs...
01 March 2021 3,703 3 View
I'm currently working having problem with the concentration for recombinant protein use in western blot, the one been used is Recombinant Human CD19 Fc Chimera Protein-rndsystem which does not...
24 February 2021 8,514 3 View
Hello, I am investigating properties of water in oil emulsion explosives. And adding hexamine (hexamethylenetetramine) into one of the phases that are used to make the emulsion should increase the...
21 February 2021 8,680 1 View
Additional questions are: What are the encapsulating atoms? How difficult was the process and what rates were achieved? What factors most seriously affect the economics?
20 February 2021 3,134 5 View
I will start to fabricate micro/nanoparticles for growth factor release and I check out a procedure quite nice, however, it is lacking some details and since I don't have much knowledge doing this...
20 February 2021 199 2 View
Hello, I am performing a western blot of my SARS-CoV-2 Spike-pseudotyped lentiviral particles. I denature my virus by adding concentrated virus to 2X Laemmli buffer at 1:1, then boiling for...
17 February 2021 4,844 4 View
I'm currently experiencing problems during acid hydrolysis for total amino acid analysis as my first samples contain high amounts of sugar (I get too low results back). I therefore had the idea to...
14 February 2021 6,049 3 View
Hello, I am trying to find kinetic information (such as rate of enzyme production etc.) on the expression of taq polymerase in E-Coli after inserting a recombinant plasmid. Any help would be...
12 February 2021 1,386 3 View
I would like to quantify a recombinant protein (with native signal sequence) secreted by Pichia pastoris using the SDS PAGE. Since my standard protein (plant origin) is not pure, I would like to...
07 February 2021 3,880 9 View