Hi,
A little bit about my work: i'm using LSPrepost to check and setting model, then i save it to Keyword file *.k, then i bring the file to LS DYNA Solver of Ansys to solve it. The thing was good, nothing error in model or setting, then the solver start. When it starts solve, the error "forrtl: severe (157): Program Exception - access violation" appear, and the solver was stop. I did have some Google search about this but nothing related much about fix this error in ansys. I checked the model and the memory needed to solve, it just ~2gb, so i dont think its about the low memory error. I did solve the model by other software and it still solve smoothly in about ~10min.
Hope someone have good knowledge about this error help me.
Thanks alot
hi there,
I came across this problem recently and my solution was to change the defined contacts. if you get this error this means somewhere in the model there is a glitch and it needs to be revised. you might also face this error with wrong input of mechanical properties.
Dear Anh.
I have the same problem.
Hopefully, your problem has been solved . So, I would be so grateful if you could guide me to solve the 157 program exception -access violation problem.
cheers,
Ahmed
I'm getting this error at the same exact timestep using different LS-Dyna versions (e.g. R901 double-precision, experimental version 110872, etc., running an explicit analysis) and with different amounts of memory allocated (from 50M to 300M). But no LS-Dyna errors are printed explaining why there would be such an error.
I have got the same problem.
I reason was that I didn't define some of the material properties (Isotropic elastic plastic material).
hi there,
I came across this problem recently and my solution was to change the defined contacts. if you get this error this means somewhere in the model there is a glitch and it needs to be revised. you might also face this error with wrong input of mechanical properties.
Dear scientists;
I have the same problem in MCNP running.
How can I fix the problem.
It is worth mentioning that I used variance reduction in my problem.
I got the same phrase. It was the contact problem between striker and the specimen. I have checked and revised it. the problem is fixed. You should check your contact card.
Had the same issue. I was specifying NCPU and Memory.
The model worked on leaving those default.
I had the same problem, and I solved the problem by specifying memory. do not set Memory to defult.
Hi, I have experienced same problem recently. I was trying to make contact SPH particles with a steel shell plate. I used Plastic_kinematic. It showed the error we are discussing. Later I have changed it to MAT98 Jhonson Crook. Now my model is working good. Even the processing time is reduced much.
I am experiencing the same problem while performing an implicit analysis. Can someone suggest any solution?
Regards
1) Check for duplicates
2) Check for free rigids or other elements
3) Check all contacts again
4)check material properties
5) sometimes part get crushed and insurted in itself which may also cause this problems.
I came across the same issue with my model. The error got fixed when I updated the contact definition.
- Badges
- Science topic