Can any one provide protocol for MIRVANA mirna mimic /inhibitor nucleofection by NUCLOEFECTOR 4D X?

01 January 1970 1 1K Report

I want to transfect mirna mimic /inhibitor to primary B cells,Can any one provide the protocol for Nucleofection of mirvana mimic ,inhibitor via nucleofector4 D X

Gamalat Allam

Can any one provide a transfection protocol for MIRVANA mirna mimic /inhibitor?

Badges
Science method

More Satyajeet Salunkhe's questions See All

CAN WE MIX Single stained beads for FLUROSCENCE MINUS ONE CONTROL (FMO) in flow cytometry? ?

Hi, For compensation, we can use single-stained beads in flow cytometry. For gating control or FMO: can we just mix single-stained beads to get FMO?

25 May 2024 6,832 1 View

Where to clone guid RNA sequence in plasmid GRNA cassete?

In 84232 add gene plasmid, I am not sure at which site should I clone guide RNA

04 April 2024 8,044 3 View

Where to clone guid RNA sequence in plasmid GRNA cassete?

In addgene 84323, plasmid they have empty gRNA casette. I am not sure where to clin guide RNA of interest. 1. Is it should be between U6 promoter and gRNA casette or 2. In gRNA casette itself?

04 April 2024 8,157 3 View

How can we use cyclic voltammetry for characterization of Microbial Fuell Cell?

I have been using the traditional method for characterizing microbial fuel cell where at the end we will obtain power density curve (Power density vs Current) and polarization curve ( Voltage vs...

14 February 2024 957 0 View

Do soda lime reacts or absorbs plant volatiles compounds?

I am doing a GC MS analysis of plant volatile compounds. I am observing that the volatile concentration of few compounds decrease in presence of sodalime. Can somebody let me know if soda lime...

09 June 2019 1,712 6 View

How mirna chose its target among 100s of mRNA having seed sequence?

I am not clear what is rule behind mirna and mRNA targeting pair,because each mirna target officially 100s of target. In such cases how one will validate legitimate mirna mRNA target. Assays...

21 April 2019 420 4 View

Films prepared by combination of Hypromellose E15 and E5 polymer with 20% of plasticizer (PEG 400) w.r.t dry polymer using water results in brittle ?

This question is related to soluble film formulation.

04 September 2018 3,223 1 View

In fragment analysis for detection of microsatellite repeat along with target fragment observed pcr fragment artifact shadow peak, how to get rid?

PET labelled forward primer for microsatellite detection along with target region, PCR artifact shadow peak of equal intensity observed. artifact since it is not visible on agarose gel.

10 March 2018 2,867 3 View

How to meassure primary miRNA trancript using QRT PCR?

I want to know how to design primer for primary miRNA QRT PCR

05 March 2018 4,991 6 View

How to draw Scatchard plot, using data of fluorescence intensity and concentrations of ligands and protein only?

How to draw Scatchard plot, using data of fluorescence intensity and concentrations of ligands and protein only. Please help..

22 January 2018 1,232 4 View

Why Do TDS and EC Increase with Larger Wastewater Volumes, While BOD and COD Decrease?

I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...

09 August 2024 9,621 0 View

Could it be a cell culture contamination?

Hello everyone! I observed in my culture (htert-RPE1 cells) an orange- red particle at the bottom of the dish. It is visible to the naked eye as a very very small red dot. Could it be a...

09 August 2024 2,824 3 View

Is there any way to quantify bacterial and fungal cells in their mixed culture?

I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...

07 August 2024 7,535 4 View

AMAXA Lonza nucleofection lower volume of buffer?

Does anyone tried to do nucleofection with AMAXA by Lonza with lower than recommended amount of buffer in the cuvettes (100 ul)?

07 August 2024 4,616 0 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

Why activated CAR-Jurkat cell could not kill targets?

Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...

06 August 2024 641 2 View

How much total RNA concentration to be extracted from sorted plasma cells from bone marrow of C57BL/6 mice for RT-PCR ?

i have sorted anti-NP specific plasma cells from bone marrow of C57BL/6 mice at certain times after immunization with variable counts and isolated total RNA using TRIZOL method for RT-PCR using...

05 August 2024 8,835 1 View

How to isolate lymphocytes from mouse spleen?

I have tried several times to isolate lymphocytes from mouse spleen, but all attempts have been unsuccessful. I tried most available protocols. I used different dissociation media (HBSS with Ca...

04 August 2024 9,913 7 View

How to Add Missing Water Molecules in Protein-Membrane Simulations?

I have protein-membrane simulations (PDB, PSF, DCD) and have noticed that water molecules near the protein are not visible in the simulations. How can I fix this issue? Is there a way to place the...

04 August 2024 1,200 2 View

How to use Density Functional Theory to calculate carrier mobilities of solid system?

Hello, everyone. I have tried to determine carrier motilities of some materials, by Density Functional Theory, using Quantum ESPRESSO. There are a few methods to do it, like a package called...

04 August 2024 8,894 1 View