What are the effects of climate change on poverty ?

What are the effects of climate change on poverty

10 November 2017 3,079 25 View

Does H-index reflects the quality of researchers?

09 October 2017 5,840 28 View

Is author's name has an effect on the reviewer(s) and journal that accepted and publish his article ?

Some articles are published in high quality journals in spite of having no enough sobriety

09 October 2017 7,549 30 View

No title

08 September 2017 2,546 9 View

What are the reasons behind the weakness of original research in Iraqi universities?

07 August 2017 5,186 23 View

What are the new trends of dye sensitized solar cells( DSSCs) ,materials and fabrication?

03 April 2017 3,365 12 View

Which is better as adsorbent RGO-N or RGO-S?

I Synthesized graphene oxide and plane to functionalized RGO as RGO-N and RGO-S . Depending on experience, which is better as adsorbent for removal methlylene blue dye from aqueous solution?

31 December 2016 5,328 2 View

To determine the concentration of reduced graphene oxide in aqueous solution, which technique is better?

31 December 2016 345 5 View

Why reduced graphene oxide have more dispersion compared to it,s solubility in ethanol ?

11 December 2016 8,522 3 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

Does Napabucasin soluble in dichloromethane and in ethanol?

I need to prepare a solution of Napabucasin (inhibitor of cancer cell stemness) in dichloromethane. The drug is expensive, so maybe somebody already tried to do it. If it is soluble, what is the...

02 March 2021 9,945 3 View

How to separate water from glycerol solvent in a solvent recovery vacuum distillation column?

I am currently doing my third year design project. I have been assigned to design a glycerol recovery column in vinyl acetate monomer production. The process unit before the recovery column is an...

01 March 2021 9,525 4 View

Why might my GFP tag be dissociating from my plasmid after transfection?

I have a set of stably transfected cell lines all transfected with plasmids containing GFP tags on the C terminus. During a western blot using anti-GFP antibody, one of my plasmids has dissociated...

01 March 2021 9,310 4 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

What is the state of the drug inside solid lipid nanoparticles (SLNs)?

I am a little confuse with the mechanism of solid lipid nanoparticles (SLNs). The main point of encapsulating drugs into SLNs is because some drugs have low solubility in water. Therefore, SLNs...

01 March 2021 3,703 3 View

Do you need the CMV enhancer before the CMV promotor for a proper function of CMV on the gene that follows?

I'm a student and I have to produce a cell line with a knockin for the NRF2 gene with GFP. I have to put a promotor in front of the GFP because the gene will be too far away from the promotor of...

28 February 2021 7,127 2 View

1 nm thick MgO thin-film to be deposited on Si wafer using thermal evaporation. What will be the optimum deposition conditions?

Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.

28 February 2021 3,640 3 View

Why am i not getting solid after reacting APTES with salicylaldehyde?

The reaction of APTES with salicylaldehyde in ethanol leads to the formation of imine compound yellow solid which is mention in literature, but I am not getting yellow solid I don't know why? when...

28 February 2021 2,955 2 View

The reason that the culture of white fungi Contamination with green mold(Trichoderma), the culture autoclave at121 for 15 min. What is it?

Is the period to autoclave not enough? The inoculation in a hood and flame and UV and alcohol.

27 February 2021 9,356 3 View