Hello every one i want to simulate the different modes of heat transfer through cement Kiln. Conductive heat transfer from clinker to inside wall of cement kiln .Convective heat transfer to outside air from cement kiln and radioactive heat transfer from the cement kiln surface. I want to enquirer which ansys module should be most relevant in modelling clinker geometry and and such modes of heat transfer.
I had tried ansys fluent for and steady state thermal module but not sure which one is more releavant
https://www.sciencedirect.com/search?qs=heat%20transfer%20simulation%20of%20cement%20Kiln%20with%20ansys&show=25&sortBy=relevance&offset=0
Use the P1 model for the radiation with solar loading model turned off. For the combustion analysis turn on the species transport model and use the premixed combustion to simplify your chemical analysis (in this case you will need to create a pdf for the 'importchemkilm'. All these are available in versions 18.0 -19.2
- Badges
- Science topic