Hy every one i want to load the wall incrementally with rate of 0.4 kN/s. i want the load to be maintained for 2 minutes at each increment to monitor the doformation of the structure .[lease guide me how i can do this
Dear Arsalan Ahmad,
You have to define an amplitude and/or frequency, you can create a table( relation between percentage of lad and increment)
I hope it helps
Hello! In Abaqus you can create a tabular Amplitude (Amplitudes - Tabular ) then you can define time/frequency and the amplitude. Another way that also you can use is using subroutines. Please fin attached a document that you can use to write subroutines.
Many times it's less time consuming to read analysis manual rather than asking a question on public forum
@Abhimanyu Kumar...I think every one is eligible enough to have some idea of what he is asking about but through public forum he get able to clear all of his doubts
@Arsalan Ahmad: The reason I said I what I said was because your question was too basic, and it's already answered in abaqus analysis manual. From experience, I can easily say that most of these type of questions could be answered just by looking into the great abaqus analysis manual. Now you being a student, there's no excuse for being lazy and asking it on a platform and wait for almost a day to get answer....on the other hand, had you looked into the manual you'd gotten your answer in less than an hour or two. Rest is your call whether to take the advice or to be lazy :)
Hi Aesalan,
I understand your situation.
If you are working in CAE then there is an amplitude function from which you can assign amplitude and time table.
Please read this through if you get some time.
http://abaqusdoc.ucalgary.ca/books/usb/default.htm?startat=pt07ch30s01aus104.html
Thanks
Dear Tilak pokhare,
sir actually my loading frquency is 40N/sec and total load is 340 KN.if i want to input it manually through excel the total data points will be more than 8500 .Which would be very lenghty,IS there alternative to this ?
- Badges
- Science topic