Is there any protocol to make chemically competent E coli from a single colony and transform it? Any buffer recipe?
Many thanks
Hello, I'm trying to make electrocompetent bacteria and store them at -20 degrees as I don't have -80 freezers. Is there any protocol? Should I use 50% glycerol? Thanks
06 July 2017 3,030 1 View
06 July 2017 6,336 1 View
10 November 2016 936 4 View
09 October 2016 8,164 9 View
Hello, I need to generate tumors in nude mice with the cell lines SK MEL 28 (melanoma) and MDA MB 231 (breast cancer), both human tumoral cell lines. How many cells do i have to inject...
05 June 2016 3,257 4 View
02 March 2016 5,205 4 View
Hello, Has anybody got any protocol to make competent lyophilized E coli?
10 November 2015 1,950 0 View
09 October 2015 3,167 1 View
05 June 2015 8,525 3 View
Searching the web i found that Zymo Research makes a kit for making competent cells and transforming them in aprox 20 seconds without incubating the mix on ice for 30 minutes, without heat-shock...
04 May 2015 3,463 4 View
Hello! I want to quantify by ELISA the secreted (from platelets poor plasma) and the non-secreted (from platelet lysate) PF4 before and after TRAP stimulation. I will use the ELISA from R&D...
03 March 2021 1,499 2 View
Hello, If i am doing a buffer exchange for an antibody of 1mg/mL, does the elution lose protein in the process of buffer exchange? For example, if i flow through 500 uL of 1mg/mL sample, and...
03 March 2021 6,299 3 View
Hello! I'll do a size exclusion chromatography, but I only have an open column, and I'll perform the peptide extraction from yeast, using buffer lysis (sodium phosphate 50 mM/NaCl 30 mM/DNAse and...
01 March 2021 2,215 2 View
Can someone please give me some possible things that could go wrong? Here is my recipe: 0.5g Agarose 50 mL of TAE 1x 1 uL ethyl bromide. Gel was run at 100V for 1 hour. The buffer used is also TAE.
01 March 2021 9,952 3 View
I'm looking at the aggregation of my protein sample using DLS. Unfortunately, my buffer (20mM HEPES) also results in a set of peaks. These are at approximately 1 and 1000 d.nm. The lowest peak...
01 March 2021 9,015 2 View
I am studying the potential of DCT and FFT coefficients extracted from a signal to classify the different objects that emit the signal. I applied the Shapiro-Wilk to confirm that data was not...
01 March 2021 8,079 2 View
I need to extract protein from fermented carbon sources for Bradford assay. Most researchers experiencing insolubility of pellet in resuspension buffer. Please assist me to select most suitable...
26 February 2021 7,129 3 View
I am facing difficulties in cloning a 1kb gene into a vector (pJIT163). I have my gene on interest (GOI) in pUC57 and want to clone in pJIT163 using SalI and BamHI restriction sites. I am getting...
25 February 2021 3,221 7 View
Hi all, I have been doing research on biotagged LDB1 proteins in Mel cells. I purify the proteins using M280 streptavidin beads. The yield is very low so I've been trying to optimize it by...
24 February 2021 5,749 3 View
Hello, I am currently using a Cas9 knock in system that will be expressed in the liver. To do so STOP codon fl/fl Cas9 KI mice were bred with Albumin-Cre mice to generate heterozgous pups, that...
24 February 2021 5,759 3 View