Hello,

I would like to determine the node numbers which make up one of the parts in my geometry in ANSYS. The way that I am currently doing this (which works, but is inefficient) is to view the Properties of a component and see how many nodes are in each part. Then, I figure out the range of nodes for the part based on the order in which the parts are defined (ie: first part has nodes 1 through X where X is the number of nodes in the first part, second part has nodes X+1 through X+number of nodes in second part, etc.).

Is there a command that I cannot find which would just give the maximum and minimum node value in a each part? This would be very helpful in the likelihood that I tweak the dimensions of this geometry.

Thanks,

Ben