Increasing pH of a solution

More Meysam Davoody's questions See All

The effect of mold, mandrel and matrix error in hydraulic press machine on lamination defect of oxide ceramics?

If we divide the factors causing lamination defects in zinc oxide ceramic parts into two categories of equipment and materials. How much is the share of each? Can the conditions of the mold,...

16 April 2024 1,926 0 View

When we use the GEB option in MCNPX code?

If I'm not wrong, the GEB option in the MCNPX code is related to the Gaussian Energy Broadening. When do we use the GEB option in the MCNPX code?

08 March 2024 9,375 0 View

CMOS circuit design?

Design of CMOS circuit to create the signal Vsig. The supply voltage is Vdd and t1 is a delay which is equal to 5ns. The picture is attached.

19 August 2023 8,893 1 View

What is the reason for the "No air pressure" error in the atomic absorption spectroscopy?

Our laboratory has a PerkinElmer (model: AAnalyst 800) atomic absorption spectroscopy. Recently, the performance of the device has encountered a problem. When the circuit breaker of the device...

22 June 2023 4,230 4 View

What are the advantages of counting photons over calculating energy they deposit in detector pixels?

What is the advantages of counting photons over calculating energy they deposit in detector pixels in dual high-energy X-Ray radiography?

13 June 2023 6,340 2 View

Low-power and ultra low-offset CMOS comparator?

I need a comparator with an offset of less than 5 mV. It is better to be designed in 0.18 um CMOS technology and the dimensions of MOSFETs should be clear. Thanks.

01 February 2022 4,640 2 View

How can the two parameters of electric current and wire feed rate be independent ?

I am optimizing the thermal spraying process by device parameters such as current, voltage, atmospheric pressure, nozzle type and wire feed rate. How can the two parameters of electric current and...

08 October 2021 2,943 0 View

What is the effect of furnace dimensions and volume on two samples with the same sintering process?

I am examining laboratory cases about the effect of furnace dimensions and volume. but I have no experience or data about that.

06 July 2021 7,503 1 View

Alzheimer's disease - Amyloid-beta plaques - available drug?

Dear all, Is there any available FDA-approved drug that can disable the formation of amyloid plaques or attenuate the progression of Alzheimer's disease once plaque formation is initiated...

30 December 2020 9,682 1 View

What is the best lubricant and dispersant for SiC abrasive particles ?

I am examining laboratory cases about ZnO Based ceramic Lapping with SiC,Al2O3,CeO2 and SiO2 abrasive particles. but i have no experience about modifying SiC slurry lapping. Also,i use of double...

13 December 2020 4,524 4 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View

How can we differentiate between calcite, dolomite, siderite, magnesite and ankerite minerals in carbonatite rocks in thin section under op microscop?

How can we differentiate between calcite, dolomite, siderite, magnesite and ankerite minerals in carbonatite rocks in thin section under optical microscope?

07 August 2024 2,132 3 View

How to assess the osmotic power of a substance?

Hello, I suspect that a molecule I am using is causing bacteria to experience osmotic shock. What chemical properties should I look for to compare this capability with those of other substances?...

06 August 2024 977 1 View

The aqueous fraction of the hydroethanolic extract is showing the presence of palmitic acid. What is the mechanism responsible ?

Palmitic acid presence in aqueous fraction

05 August 2024 8,624 4 View

XRD Analysis is showing only Calcium carbonate. It is not showing other compounds. Can anyone help me get the other compounds?

XRD Analysis is showing only Calcium carbonate. It is not showing other compounds. Can anyone help me get the other compounds

04 August 2024 3,019 3 View

How to convert g/kg Humic acid dose to kg/ha?

I used humic acid at 0.044 g/kg soil in my pot experiment. But finally, I have to recommend kg/ha. Each pot's soil weight was 11 kg. What is the solution?

02 August 2024 7,186 6 View

Looking for help on sem image analysis?

Hello I am conducting a microstructural analysis of a soil treated with lime. The following sem images are of the untreated s1 and treated soil s3. The untreated soil contains quartz calcite...

01 August 2024 572 0 View

Inquiry on Maximum Nucleic Acid Volume for 2.5 mL Liposome Solution?

I am currently working on a project involving liposomes and need to determine the maximum volume of siRNA that can be added to a 2.5 mL liposome solution with a total lipid concentration of 10...

30 July 2024 6,420 1 View

How to check pH of a high strength hydrogel?

We are working on biopolymeric hydrogels. Our system is highly viscous and sticky, and the gel formed are high in strength. We are unable to use pH electrode and pH strip. Please suggest an easy...

30 July 2024 942 2 View

EDTA buffer solution?

Hello everyone! How can i prepare EDTA buffer solution (pH 8.2) to determine GSH levels? Thank you in advance.

29 July 2024 4,374 1 View

Nirmala S.V.S.G

Hello Meysam Davoody

please check the resources related to your topic

www.advancedaquarist.com › Volume I › June 2002

www.phadjustment.com/pH.html

Meysam Davoody

Hi Nirmala,

Thanks for the materials.

Alfonso Mucci

Hard to tell, depending on your ultimate goal. If it is to increase the yield of CaCO3 precipitated, NaOH should do.