I am simulating Id-Vg from Vg -6 to 2 V GaN HEMT on Sentaurus TCAD, Can someone please tell as how to remove the issuedescribed below?

Shivansh Awasthi @Shivansh_Awasthi4

14 March 2023 1 3K Report

Solution is not converging after gate voltage reaches 1.34 V and Id is 200mA

Manish Verma

Shivansh Tripathi,

i think.... you have to modify mesh size of your structure.

Badges
Science method

How can i resolve the "final solutuin is not converged" error in Comsol for my heat transfer simulation??

I have been trying to simulate heat transfer problem in Comsol 5.5 for long time but it always throw an error stating: "Failed to find a solution. Maximum number of Newton iterations...

28 February 2021 8,626 3 View

How to approach CFD simulation results of a flow past a cylinder?

Hi all, I'm doing a transient simulation of flow past a rectangular cylinder close to the free surface. As far as I'm concerned, the common practice is to discard the initial stages of the...

25 February 2021 1,348 3 View

Error in comsol?

Dear respected researchers, while performing CFD analysis in Comsol it's showing like this Error: Nonlinear solver did not converge. The maximum number of Newton iterations reached can...

24 February 2021 249 3 View

How to overcome convergence issues in concrete arch models?

Hi, I have modelled a three-span arch bridge with soil fill over along with pedestals. The FE modelling is done in LUSAS with HX8M solid elements (i.e. 3D solid modelling). The non-linearity is...

20 February 2021 1,346 2 View

How can I plot surface potential vs Gate voltage in Sentaurus TCAD?

Currently, I am working on a project in Sentaurus TCAD for which I required the plot of Surface Potential Vs Gate Voltage. Can anyone help me finding the simplest way or a different procedure for...

18 February 2021 1,213 2 View

Comsol Maximum number of Newton iterations reached?

Comsol is investigating deformation due to gravity. Gravity is applied to the nanosheets to check for displacement and stress. If I input the Young's modulus of the channel to about 1 [GPa], the...

15 February 2021 6,027 3 View

Vth increase with programming SONOS Flash in Tcad?

Hello, I've been working on this issue for more than a month now.... I made a basic SONOS flash structure using TCAD Sentaurus sProcess. (tunnel oxide/nitride/blocking oxide : 4/6/6 [nm]) Then,...

11 February 2021 3,337 3 View

Why is my vc-relax computation of a W-based material is not converging? What important factors should I consider to attain convergence?

Here are some of the parts of the input file: &system ibrav = 0, nat= 9, ntyp= 2, ecutwfc = 36.7, ecutrho = 367, smearing = 'methfessel-paxton', occupations = 'smearing',...

10 February 2021 4,689 1 View

How to conduct mesh sensitivity/convergence analysis in MSC Marc Mentat?

Currently using Msc Marc Mentat for FEA. Now i conduct the mesh convergence/sensitivity analysis manually. So I need to know if there any automatic way to conduct the mesh convergence/sensitivity...

04 February 2021 3,310 3 View

How can I solve problem with my sentaurus workbench?

My Sentaurus workbench tools (SDE, SDEVICE & SVISUAL) Command window stopped opening. The command window is accessed as follows, right click SDE > select Edit Input > click on the...

29 January 2021 8,189 3 View