How to prepare stock solution of melatonin to use for electrochemical detection?Which solvent is more suitable?

More Shamim Ahmed Hira's questions See All

How to model the battery pack in PSIM or PSCAD?

Hello, I have simulated a single battery cell using Thevenin equivalent circuit. For a battery pack, I have a large number of cells connected in series and parallel connections. Is there any way...

28 February 2021 2,116 1 View

I am looking for a IoT simulator ?

I am working on a university project so, I m looking for a good Simulator compatible with LoRa and LoRaWAN protocol to simulate an IoT scenario. Thanks in Advance

20 February 2021 6,352 6 View

Why according to FRAC (fungicide resistance action committee) phenylamide fungicides application interval should not exceed 14 days?

Why according to FRAC (fungicide resistance action committee) phenylamide fungicides application interval should not exceed 14 days. Anyone know reason behind this strategy

18 January 2021 1,166 3 View

What are the political factors affecting curriculum design at the primary level in Pakistan?

This Topic I chose for my Thesis in Final Year of my Master's. I am in process of it's completion but need more suggestions and comments for the Topic to elaborate.

14 December 2020 356 3 View

How to calculate the replacement cost of battery?

As battery needs to be replaced after the specific charge and discharge cycles mentioned in the datasheet. If we have the time series data of battery power and energy capacity, then how can we...

01 December 2020 3,433 3 View

How to coat oleic acid on fe3o4 nanoparticles and yo confirm visually?

I made iron oxide nanoparticles via co-precipitation method and obtained a brown colour slurry with neutral pH and I did ex situ coating of oleic acid on nanoparticles and washed it with ethanol...

10 November 2020 5,911 4 View

Can anyone please elaborate the relationship between charge and discharge cycles and battery lifetime?

I am designing the optimal HESS capacity for the renewable system. I have to select the cutoff frequency of low pass filter to divide the low and high-frequency components. charge and discharge...

05 November 2020 8,397 3 View

How to select the frequency range in MATLAB Wavelet toolbox?

I have a continuous, time-domain noisy signal and want to decompose into low-frequency (LF) and high-frequency(HF) components using Wavelet Toolbox. But, I am unable to select the frequency range....

29 October 2020 5,219 5 View

How to confirm coating of oleic acid without using any XRD,SEM,FTIR???

I made iron oxide nanoparticles via co-precipitation method and obtained a brown colour slurry with neutral pH and I did ex situ coating of oleic acid on nanoparticles and washed it with ethanol...

28 October 2020 1,802 3 View

How can i remove fungus from mushrooms without killing its spores?

I bought some shiitake mushrooms. now they have fungus. is there a way to remove fungus without killing the spores

06 August 2020 6,358 4 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

Does Napabucasin soluble in dichloromethane and in ethanol?

I need to prepare a solution of Napabucasin (inhibitor of cancer cell stemness) in dichloromethane. The drug is expensive, so maybe somebody already tried to do it. If it is soluble, what is the...

02 March 2021 9,945 3 View

How to get started building and analyzing a UTAUT model?

Hello all, I need help getting started building and analyzing a UTATU model. I have a survey ready with some questions but I had some confusions on UATAUT and on how to analyze the data. I will...

02 March 2021 9,271 1 View

Could anyone tell me what is the range of submillimeter wave?

There is confusion regarding the submillimeter-wave range. Many papers specify its range from 300GHz but some also consider its range from 100GHz. If I design an antenna on 122ghz what would I...

01 March 2021 516 7 View

Why am i not getting solid after reacting APTES with salicylaldehyde?

The reaction of APTES with salicylaldehyde in ethanol leads to the formation of imine compound yellow solid which is mention in literature, but I am not getting yellow solid I don't know why? when...

28 February 2021 2,955 2 View

Why initial concentration of Pb not the same as calculated one when testing using AAS?

I am currently doing research on the adsorption of heavy metal using magnetic reduce graphene oxide. I use AAS to determine the concentration of the heavy metal. I prepare the Pb solution with...

26 February 2021 9,580 4 View

Is there anyone who experienced with cytotoxic effect of Hoescht 33342 dye?

Is Hoechst toxic to cells? In general, it is known as non-toxic. I am working with dsRED MDA-MB-231 cell line. I applied it for my PDMS-based microfluidic platform, for this reason, I incubated...

26 February 2021 9,119 3 View

Calculating volume of DNA required from DNA concentration?

Hi I am a bit confused. They are asking me to find out the volume of DNA required in ul (a total of 30-100 ng for genomic DNA) from the DNA concentration in the nanodrop reading which was 404.8...

26 February 2021 5,029 2 View

Why CNN algorithm performs well in Network Intrusion Detection based on some recent resources?

Most of the papers have compared different hyperparameters such as layers, initializers, activation function, and optimizer algorithm in the CNN algorithm for detecting network intrusion. This is...

24 February 2021 4,578 4 View

How to best wash a 96-well plate containing microplastic?

I am planning my protocol for my dissertation for an experiment quantifying bacterial (E. coli) biofilm formation on micro-plastic (5mm discs of polyethylene bags) by conducting a crystal violet...

23 February 2021 7,868 2 View

Frank T. Edelmann

Dear Shamim Ahmed Hira, please find attached an information sheet detailing the solubility properties of melatonin. Apparently pure water is not a good choice.

Firas A. Al-Lolage

According to the specification sheet given by Santa cruz biotechnology it's solubility in water (0.1 mg/ml), ethanol (8 mg/ml), benzene, chloroform, methanol, DMSO (50 mM)