The procedure compute?

02 March 2021 5,204 3 View

One-sided testing of MLM in R?

Dear colleagues, Does anyone know how to conduct a one-sided testing of regression weights (MLM) in R? The actual model is fm1rs

23 January 2021 3,970 3 View

[Measurement invariance] - Do you test it on the full SEM model, on each construct separately, or both?

Hi everyone, I would like to know whether both cultural groups interpreted my questionnaire in a similar way. To do so, I conducted a measurement invariance analysis on the whole model of latent...

14 January 2021 1,845 3 View

Is it possible to do a closed loop control of a sine wave?

An analogue voltage sine wave signal is send from a PLC to a Piezo actuator. This actuator converts the voltage to force. A load cell checks what the applied force is and sends a mA-signal...

27 December 2020 7,037 3 View

[SEM] Why RStudio and AMOS report different p-values (but same estimates)?

Hi everyone, I have conducted a SEM analysis in AMOS then replicated it in RStudio. While I obtained identical estimates and model fit statistics, the p-values differ between software programs...

25 December 2020 3,669 4 View

What should my boundary conditions be in abaqus and how do I apply a sine load?

I want to model a T bone specimen that is subjected to a sine load. The specimen is clamped in as showed on the figure. I was wondering what I should chose as boundary conditions and how I can...

08 November 2020 9,766 4 View

Does anyone know instruments to measure "mental health literacy" in teachers?

Hi there, I am looking for questionnaires measuring mental health literacy in teachers and educators. does anyone know any studies in this area?

16 September 2020 1,682 4 View

Is there any possibility to get the estimated values (listed for every participant) of a specific latent variable in R or Mplus?

Is there any possibility to get the estimated values (listed for every participant) of a specific latent variable in R or Mplus?

17 June 2020 3,819 3 View

Literature for multilevel MCMC models?

Hey there, I am looking for literature or tutorial videos, which are concerned with the question of how multilevel markov chain monte carlo models are conducted in R or Mplus. Can someone help...

20 April 2020 7,801 1 View

P-values for Odds Ratio in R or Mplus?

Dear collegues, Does anyone know, how I can generate a p-value for an Odds Ratio using R or Mplus concerning a multilevel (multiple/simple) logistic regression model? Thank you very much in...

26 February 2020 3,771 4 View

How to compare two groups with only two measurements?

Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...

03 March 2021 8,796 3 View

Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence?

I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance

03 March 2021 3,568 1 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10?

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...

03 March 2021 1,401 3 View

Logistical regression using SPSS for a dichotomous dependent variable, with an independent variable of 1, 2, 5 and 10 seconds?

I have an experiment with 28 participants The independent variable is the times 1, 2, 5, and 10 used as the cross hairs during a task These 4 times were tested using 4 different blocks, each...

03 March 2021 9,692 2 View

Do we need to write protocol for a second study of a systematic review that has been registered and published?

I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...

03 March 2021 8,920 3 View

How to increase a model accuracy ?

dear community, my model is based feature extraction from non stationary signals using discrete Wavelet Transform and then using statistical features then machine learning classifiers in order to...

03 March 2021 6,994 5 View

Do I need to do linear regression before running mediation analysis using PROCESS MACRO by Hayes ?

I just wanted to check if I need to run a linear regression separately if I am using PROCESS MACRO to run mediation analysis. Thank you.

02 March 2021 4,359 3 View

How to normalise data on OPM package from R Studio ?

Good afternoon, I recently used OmniLog from BIOLOG for my experimentations : I tested the metabolism of different strains on 2 types of plates. I have 16 strains of 3 different groups...

02 March 2021 3,584 1 View

Sample dilution for quantitative analysis using ELISA?

If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis

02 March 2021 7,670 3 View