Hello. why do we measure surface tension?

Alireza Mirhosseini @Alireza-Mirhosseini

21 May 2024 1 5K Report

surface tension

Surface tension as a physical property shows up in calculations, including droplet and bubble sizes plus heat transfer coefficient.

Badges
Science topic

More Alireza Mirhosseini's questions See All

What do you know about classroom management?

Hello, if possible, please send me new methods of management and communication in the classroom. thank you؟

18 June 2024 4,139 3 View

How do we measure the electrical conductivity of this magnetic nanocomposite?

A magnetic nanocomposite has been synthesized and its electrical conductivity needs to be measured. What analysis and technique can be used to measure the electrical conductivity of this magnetic...

16 June 2024 7,488 3 View

Is it possible to estimate Horizontal in-situ stresses' directions and magnitudes from seismic data by using AI methods?

We know that one of the important members of a 3D Geomechanical Model is in-situ stresses' directions and magnitudes. we can use the seismic data to estimate these parameters in special record...

21 May 2024 1,332 2 View

What are the S-scheme and Z-scheme heterojunctions in photocatalytic systems? for the types of heterogeneous photocatalysts, how can you determine?

what are the S-scheme and Z-scheme heterojunctions in photocatalytic systems? and for the types of heterogeneous photocatalysts, how can you determine the type of S-scheme and Z-scheme?

16 May 2024 1,545 1 View

Why is my first article being rejected fast by related journals?

Hello everyone, I hope you are all doing well. I have already checked plagiarism, related articles’ structures, and grammar, and they seem fine, but good impact factor journals that I have written...

15 May 2024 1,007 4 View

Altitude control of a quadrotor ?

hi there i'm working on quadrotor path tracking in matlab's simulink . there is an inner loop which is responsible for tracking the desired euler angles generated by the outer loop . feedback...

05 May 2024 7,705 5 View

How to perform LC-BLYP calculation with GAMESS?

Hello Dears, I am currently working on time-dependent density functional theory (TDDFT) calculations for both singlet and triplet states using the LC-BLYP functional in GAMESS. I believe I have...

01 May 2024 4,614 0 View

Does Baicalein interact with DMEM high glucose or FBS?

greetings, I'm culturing SW480 cells on DMEM high glucose gibco with FBS. When I'm performing MTT Assay, upon treatment of cells with Baicalein, the color of medium with 5% FBS changes to dark...

25 April 2024 7,115 4 View

I'm getting error:( Domain error. To compute complex results from real x, use 'sqrt(complex(x)) ) in simulink?

hi there . i'm currently working on a thesis which involves designing a fast nonsingular terminal sliding-mode controller for attitude control of a quadrotor. the outputs of sliding mode...

20 April 2024 425 2 View

Is there any information about Physical and mechanical properties of Neodymium hydride - NdH2?

I am doing research about formation of neodymium hydride by exposing the NdFeB magnet to hydrogen, but I couldn't find any mechanical properties such as young's modulus or other physical and...

31 March 2024 3,863 0 View

Can I proceed with Response Surface Methodology (RSM) with only one factor for further optimization?

I went for Plackett Burman Design for selecting the optimization factors of growth conditions for pesticide degradation. I started with 7 parameters. But, after the experiments and analysis, only...

29 July 2024 5,015 1 View

I did hirshfeld surface analysis for molecule but did not find red spot and interaction surface in energy frame work, is it ok for research article ?

In hirshfeld surface calculation i did not find any red spot in hirshfeld surface, is it ok for research article to write?

28 July 2024 2,988 0 View

Why specific capacitance is not proportional with the specific surface area?

Dear researchers, Why specific capacitance is not proportional to the specific surface area? I have material A with a surface area higher than material B, but material B is showing little bit...

26 July 2024 9,156 2 View

Differences between Surface Tension and Interfacial Tension in Liquid-Gas Phases?

Hi everyone, I have a question regarding surface and interfacial tension. Although I understand that these tensions are studied for different purposes, can they be considered equivalent in the...

18 July 2024 382 5 View

Roughening Silver Electrode Using CH Instruments for SERS applications?

I am in the process of roughening a silver electrode for SERS measurements using the latest version of CH Instruments. Most procedures in the literature mention sweeping the potential from -0.3 V...

30 June 2024 4,639 3 View

How closely does an elastic sheet conform to what's below it?

See the attached file for an illustration of this problem. Consider an elastic sheet S (orange) that’s laying atop a solid base B (blue). The sheet is under tension (arrows) and is held to the...

30 June 2024 747 4 View

What kind of surface morphology must be there for good photocatalytic activity of thin film?

If I want to increase the photocatalytic activity of a thin film sample what should be it's ideal surface morphology and parameters? All scientific answers related this are highly appreciated.

19 June 2024 6,744 0 View

What surface modification procedures can be employed to enhance the interfacial bonding between the resin matrix and filler particles in dental compo?

What surface modification procedures can be employed to enhance the interfacial bonding between the resin matrix and filler particles in dental composites?

12 June 2024 9,363 1 View

What is the physical or chemical background of the thermal behavior of polyester microfiber fabrics?

I am currently working on my bachelor thesis in the field of back injection molding of textiles made of polyester fibers. We have achieved quite good results with thermal treatments to restore the...

01 June 2024 2,457 3 View

Is it normal for BET surface are of the synthesized material have some difference with the reference paper?

Hi, currently i am studying the different structures of MnO2 and i do a BET surface analysis to see the BET surface area. For my synthesized material alpha-mno2 has a BET surface area of 122,...

22 May 2024 3,559 2 View