19 February 2015 6 2K Report

I have found piezoelectric resonance peaks for my sample so in further I have to take terahertz characterization.

More C. Ranjith Dev Inbaseelan's questions See All
Are diatom inclusions found in shellfish shells?

Mangroves were reported to eat into limestone atolls like so much cake - but could it have been diatom partnerships at mangrove roots that ate into the rock? If gypsum formation is a clue, how...

12 July 2024 159 2 View

Validated HPLC method for the estimation of the Amphotericin B ?

During the release test of Amphotericin B using 1% Tween 80, i observed three peaks even in the standard. The first peak consistently yielded results around 500%, while the other peaks showed...

08 July 2024 1,330 0 View

Issue with micrometer beam size while simulating moving heat source problem?

I am trying to replicate results published in the journal paper published recently (Modeling of Laser-assisted micro-milling Inconel718 ). In that paper, they used vdflux subroutine to obtain...

05 July 2024 3,701 0 View

How to produce homogeneous reference gene bands in Western Blot?

Hello, I have been performing Western Blots to study the protein levels of a rodent skin and muscle sample. However, I have not been able to produce homogenous reference bands. I suspect that...

26 June 2024 5,913 3 View

Do you think undergraduate teaching via online platforms like zoom is sufficient to teach theory parts of Science subjects?

When I analyzed grades of undergraduates, some course taught via online platforms, their grades are lower than the physical lectures.

11 May 2024 7,475 4 View

Why Agroforestry not popular among farmers?

Agroforestry is considered and identified as a good land management practice. But most of the farmers prefer monoculture or mixed cropping system, But not agroforestry provide lots of tangible and...

09 May 2024 2,376 2 View

Which is the correct keyword for NLO calculations?

Hello, I hope this message finds you well. I have just started to learn gaussian software. While running NLO calculations I used the keyword: #p b3lyp/6-31g(d,p) geom=connectivity gfinput...

08 May 2024 6,756 2 View

Is it necessary to incorporate deformation energy and entropy corrections when calculating MMPBSA binding free energy in Protein-ligand complexes?

The inclusion of deformation energy and entropy corrections in MMPBSA binding free energy calculations is common in studies involving DNA-ligand complexes. However, in the literature, these terms...

25 April 2024 7,286 0 View

How to do Thrips Egg staining?

In order to view/ find the laid thrip eggs is there any methods is available, if yes, suggest me the methods.

23 April 2024 7,873 0 View

Would like to learn about Auguste Levasseur, Lafayette's friend and author of the book on their visit to the United States in 1824-25?

The Marquis de Lafayette is "returning" to America again this fall. After serving in the American and French Revolutions, he returned to America in 1824-1825 and toured some 25 states. This...

19 April 2024 4,979 0 View

Similar questions and discussions
How to correctly use the UTE and ZTE pulse sequences in Bruker's ParaVision software?

I am using a Bruker 600M solid-state NMR spectrometer with a Micro 2.5 microimaging system. The test sample is a tube of 1M LiCl aqueous solution, and the nucleus detected is 1H. I am trying to...

01 August 2024 9,227 1 View

What is single absorption ESR spectroscopy ?

In the context of Electron Spin Resonance (ESR) spectroscopy, under what conditions is an absorption spectrum considered to be a single absorption spectrum?

25 July 2024 2,325 1 View

Why electrical charge on the moving plate increase?

Hi, everyone This figure depicts a simulation of an electrostatic energy harvesting system in COMSOL Multiphysics software. My question is regarding the relationship between the changes in...

19 July 2024 4,694 4 View

How Can I Resolve a Persistent Unwanted NMR Peak at 1.25 ppm?

Hello everyone, I am facing a consistent issue in my NMR spectra with an unwanted peak appearing at 1.25 ppm. This peak seems to vary with the amount of sample: it becomes more pronounced with...

15 July 2024 9,065 4 View

What are the criteria that must be retained for the development and validation of a qualitative NMR method ?

Dear Community, I would like to develop and validate a qualitative NMR method for the analysis of a specific category of chemicals, and my question is the following: What are the criteria that I...

08 July 2024 1,402 4 View

How to conduct the NMR study of a nano-composite film?

Solid state NMR study

03 July 2024 422 1 View

I have NMR,Mass spec,IR and uv of a mixture of three unknown compounds from natural products.I am attaching the data who can help me elucidate?

I isolated a mixture of three compounds from the stem bark of a plant . I have NMR, Mass spec, IR, and UV data. There are a lot of things I can't make meaning out of. Kindly help me with the...

02 July 2024 9,531 4 View

Problem Justifcation of below research topic?

Analyzing the effectiveness of apply the Extended Producer Responsibility (EPR) concept for reducing pre-consumer apparel waste within a Star Fashion Pvt Ltd apparel company.

30 June 2024 3,764 0 View

COMSOL simulation of transient wave optics propagation is not physical?

Hi guys, I am trying to simulate a 1 ps long plane wave propagating in a dispersive material, with the wave optics transient module. According to the drude-lorentz model, when the frequency of...

29 June 2024 486 1 View

What is it that can affect the energy harvesting performance of a PVDF nanogenerator ?

I have made a PVDF film and now I am trying to see the film's performance. I have made contacts on the film with the help of silver paste and attached copper strips as electrodes. But, I am not...

24 June 2024 8,671 0 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close