I want to look at dendritic cells by flow cytometry.
I've been using Collagenase IV plus DNase I in blank RPMI1640 media.
Hey,
it depends on the cells you want to analyse. T-cells? Dendritic cells/macrophages? Endothelial cells? Do we talk about mouse thymus?
It depends on the cells you would digest and also in addition to the two enzymes you used ,also phospholipase must be used
Does anti-CD62L antibody lead to some form of signaling on the naive T cells?
07 August 2018 2,772 2 View
I see that their emission spectrum overlaps entirely, but I've seen this combination being used, apparently successfully.
07 August 2018 4,900 6 View
Can I use anti-CD11c-PE and anti-TCRb-PE in the same staining panel since they are expressed on different cells?
06 July 2018 2,055 1 View
Hello, I am looking for any online reference on any/all available protein expression data on any cell type to aid in the optimal design of flow cytometry panels. If anyone knows of any such...
01 February 2018 6,039 3 View
I am newbie to flow cytometry. I use a LSR fortessa with FACSDiva software. When I run compensation controls, I have to set the voltages for each comp control to minimize the histogram overlaps...
11 December 2017 2,749 0 View
I am quite new to flow so I was just wandering if I have to do it every time. Seems I can use previous compensation setting.
10 November 2017 3,514 2 View
Is there an alternative to FMO controls if you don't have enough cells for FMO controls?
10 November 2017 8,443 3 View
see question
09 October 2017 509 0 View
I am flowing a lot of cells per sample
09 October 2017 2,419 3 View
The blocks were cut into 6um sections and let float in 43C water bath before scooping up with microscope slide (time in water approx
31 December 2015 2,683 4 View
How to calculate the RMSD values for a MD simulation using MOE?
07 August 2021 0 0 View
When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.
16 June 2021 0 0 View
Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...
03 March 2021 5,978 5 View
02 March 2021 3,060 3 View
Hi, I am trying to construct a multi-layer fibril structure from a single layer in PyMol by translating the layer along the fibril axis. For now, I am able to use the Translate command in PyMol...
02 March 2021 4,569 4 View
Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...
02 March 2021 3,024 2 View