I have a pattern geometry, with one block being repeated 60 times. Is it possible to make one just one block and mesh it, then to copy this geometry and mesh. It would really help me a lot of work and avoid miss clicking. Thank You.
Franco Concli
In Ansys fluent you can load several time the mesh as separate blocks, shift them and add an interface between them.
2 votes
2 thanks
Muhammad Furqan Ali
Dear Franco Concli ,
thank you for this answer.. Can we separate mesh from case and data file ? I have a case and data file , I want to separate the mesh and modify it on Gambit.. Please guide.
0 votes
0 thanks
Abhinav Mohite
Thank You Franco. I was able to append the mesh but could not shift the mesh. Both the meshes are over lapping. Could you help me with it? Thank You.
1 votes
1 thanks
- Badges
- Science topic
More Abhinav Mohite's questions See All
Similar questions and discussions