I am using 1/50 dilution of (50-250 microgram concentration) and 3 ml of H2O2 but absorbance of sample continuously increasing. Or some time negative absorbance also getting I don't understand what is the result behind it.
Thank you in advance
Dear Mohini ,
There are many issues that you need to check.
1-did you use quartz cell?
2- did you use dry or fresh sample?
however, the negative absorbance indicates that the sample does not contain enough enzyme that mean that you need to decrease the dilution ratio
To be sure that there is an activity you should try different volumes of the diluted as well as of the undiluted extract.
Good luck.
H2O2 used for this dilution is more proportianately reduce the vol f H2O2
After successfully synthesizing selenium nanoparticles from plants using water my next objective is to assess their antioxidant activity. However, I encountered an issue during the drying process...
18 January 2024 3,156 3 View
Good evening everyone I am working on green synthesis of selenium nanoparticles from leaf extract. The research article mentions that during selenium nanoparticle synthesis, ascorbic acid should...
24 September 2023 4,015 2 View
ABTS can dissolved in both water and organic solvent. for ABTS assay we can used trolox catechin and ascorbic acid as standard, but mostly ascorbic acid used as standard, and why. why ABTS assy...
09 July 2023 3,455 3 View
i want to use 1mg/ml to 5mg/ml concnetration for antioxidant assay. my total drug concentration (mother drug ) is 12mg. how to calculate 1-5mg/ml con. from mother drug if total reaction volume is...
30 January 2023 9,656 2 View
i want to add my data on abstract for my research paper so how to calculate and plot the values in that and also from which value we have to calcualte the standard deviation
22 December 2022 7,017 1 View
coumn length is 50 cm and unretained marker takes 2 min to be detected. calculte the resolution for the peaks (A-B, B-C) how long must the column be in order to have baseline resolution? assume...
24 November 2022 8,732 1 View
i have done triplicate experiment for nitric oxide assay and i take 25-225ug/ml concnetration. and i got 3 absorbance value for each concnetration. but dont understand how to calculate IC 50 value...
01 September 2022 5,792 1 View
i am doing metal chelation assay for that i used iron (II) Chloride tetrahydrate and ferrozine. i take 0.1 ml iron (II) chloride tetrahydrate in test tube and added 0.2ml ferrozine as a control...
18 July 2022 3,301 0 View
in coffee I am observing that primary callus is mainly formed on the midrib section and the lateral veins present on the leaf. the callus doesn't form on all the 4 sides of the leaves except the...
09 February 2022 8,593 2 View
Give me details calculation.
03 January 2022 8,346 1 View
I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...
10 August 2024 8,539 5 View
How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?
09 August 2024 7,718 0 View
Palmitic acid presence in aqueous fraction
05 August 2024 8,624 4 View
Hello. I am working on ROS production of two systems: system A is cerium oxide and hydrogen peroxide, system B is cerium oxide nanoparticle, hydrogen peroxide and potassium bromide. I did some...
04 August 2024 5,974 3 View
I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...
03 August 2024 4,725 2 View
I heard an explanation about something being a better proton acceptor or lone pair donor but that doesn't make sense. I couldn't explain in in terms of acid-base theory. The hand-waving way I saw...
03 August 2024 9,918 0 View
I am conducting a systematic review and meta analysis; as I am extracting data I realized there is a consort diagram that shows the number of patients from randomization till end of the study. So...
01 August 2024 9,993 3 View
I'm trying to calculate the tolerance factors of the hydride perovskite and the value calculated by me and the reported values are contradictory. Need more clarity in using the correct ionic radii...
01 August 2024 2,614 1 View
99% pure ethanol was used for maceration also alternate methods along with the temperature and time to concentrate the extract can be specified
31 July 2024 5,113 4 View
We conducted an antibacterial study of a plant extract. Varying concentrations of crude extract were subjected to microbroth dilution assay. The result showed that only the lowest concentration of...
31 July 2024 8,666 3 View