When I do the evaluation in postprocessing I get the error-
Template based post-processing result "Gain (IEEE),3D,Max. Value (Solid Angle)": Error in calling "Evaluate1D" function (No calculated Farfield Result with correct excitation string found.)
Dear Ria
Please follow the following steps :
1. Define the field monitors in the monitor window with the frequency points or transient broadband as required frequency range----> simulate
2. Open template based postprocessing window------> farfield and antenna properties----->farfield result--------->all settings---> set plot mode to Gain(IEEE)/realized gain---> frequency setting to broadband----->evaluation range as required---->OK------> Evaluate.
You will get the gain v/s frequency plot in specified frequency range.
Hope you find the answer!!!
Hello,
CST help pdf is attached and I hope, this will solve the most of the problems.
Thanks,
Hello,
Firstly, to see the Results and chose Template Based Postprocessing and apply Farfield and Antenna Properties and Farfield Result and than like on the pic. And after that, it`s possible to get plot like on next picture, for instance. Set up a post processing template to pull out the directivity as a function of frequency, it's a 1D template.
Thanks,
Hello,
Kindly add a broadband farfield monitor then run the simulation. Now you can go for post processing..For settings, see attached file.
Hope this helps, let me know for more information.
If i feed the patch antenna with two prop feed , and make waveguide port for each feed for making circular polarization ( i made phase shift 90 )
.
why there is the same error
No calculated Farfield Result with correct excitation string found
- Badges
- Science topic
- Similar topics
- Engineering
- Materials Engineering
- Annealing
- Metallurgy
- Metals