18 August 2015 1 594 Report

which buffer should I use?? in what conditions?? 

More Konstantin Rozenberg's questions See All
Formation of a target organizational and functional model for data management in space activities?

Formation of a target organizational and functional model for data management in space activities

10 July 2024 4,498 0 View

What connection can there be between politics and collective intelligence?

I am interested in reflecting on the political dimension of collective intelligence.

13 April 2024 2,811 18 View

How can the concentration of colloidal particles in an aqueous solution be determined?

How can the concentration of colloidal particles in an aqueous solution be determined? Is it possible to apply the photo-colorimetric method for this?

11 October 2023 1,563 21 View

Where can I find data about viscosity dependence on concentration in methanol–poly(vinyl acetate) solution?

Where can I find data about viscosity dependence on concentration in methanol–poly(vinyl acetate) solution? What value of saturation concentration and diffusion coefficient for the solved polymer...

11 April 2023 3,414 2 View

Is there the state support for medical insurance of radioisotope diagnostics in your country?

Radioisotope diagnostics of many diseases is currently available in many countries. But this is often an expensive procedure. Does your country provide state support for medical insurance for...

01 April 2023 3,895 7 View

I'm looking for a good review article/book chapter about parrallel methods based on simulated annealing. Any recommendations?

I am currently studying the application of simulated annealing techniques to optimization problems. In particular, I am interested in applying the optimization method to the study of Ising models....

21 November 2022 2,663 1 View

Amplification in regenerative amplifier by cw pumping?

Hello. In real moment I'm designing the CPA system for my Ti:Sa laser. I have only cw diode module for pumping (10 W). How can I evaluate amplification opportunity in 'regen'. I want to gain from...

18 September 2022 5,450 1 View

Why is there increase of electrode atomic forces when applying bias voltage in TranSiesta?

Dear colleagues, I am trying to calculate I-V characteristics for typical (Left electrode) - (Device) – (Right electrode) system. Besides the well-known problem of difficult electronic...

27 March 2022 8,532 11 View

How to block an IR beam in vacuum?

Hallo, I've a HHG setup, but the IR filter is broken. This means that the entire IR intensity hits the CCD camera and would destroy it. Because a replacement filter needs a few weeks to arrive,...

27 February 2022 5,470 1 View

How to determine the fraction of DNA from lymphocytes in the blood?

I'm thinking about how to detect in circulating free DNA fraction that comes from white blood cells. Now my idea is to use T cell receptor excision circle (TREC) and kappa-deleting recombination...

01 June 2021 5,918 0 View

Similar questions and discussions
Why Do TDS and EC Increase with Larger Wastewater Volumes, While BOD and COD Decrease?

I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...

09 August 2024 9,621 0 View

Could it be a cell culture contamination?

Hello everyone! I observed in my culture (htert-RPE1 cells) an orange- red particle at the bottom of the dish. It is visible to the naked eye as a very very small red dot. Could it be a...

09 August 2024 2,824 3 View

Is there any way to quantify bacterial and fungal cells in their mixed culture?

I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...

07 August 2024 7,535 4 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

Microtome tissue sectioning - How to prevent chatter of paraffin tissue specimen sections?

Hello everyone, I have recently started using the microtome device for sectioning of paraffin-embedded mice lung. While I had some success in sectioning and observing proper ribbons, some of my...

06 August 2024 666 4 View

Why activated CAR-Jurkat cell could not kill targets?

Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...

06 August 2024 641 2 View

Weak DAPI staining after immunohistochemistry - how to improve?

After immunohistochemistry of previously fixed in PFA and EtOH and then frozen 20 μm sections of zebrafish brain, DAPI staining is very weak (right) compared to the same sections stained without...

05 August 2024 9,637 2 View

Do you have good tips for seaweed tissue preservation in the field for post RNA extraction?

I will be with my students collecting seaweed samples in a marine farm and later we will process this tissue for RNA isolation and further sequencing. Does anyone have tips on how to collect the...

04 August 2024 501 2 View

How to isolate lymphocytes from mouse spleen?

I have tried several times to isolate lymphocytes from mouse spleen, but all attempts have been unsuccessful. I tried most available protocols. I used different dissociation media (HBSS with Ca...

04 August 2024 9,913 7 View

How to Add Missing Water Molecules in Protein-Membrane Simulations?

I have protein-membrane simulations (PDB, PSF, DCD) and have noticed that water molecules near the protein are not visible in the simulations. How can I fix this issue? Is there a way to place the...

04 August 2024 1,200 2 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close