Does anybody have a substrate equilibrium buffer recipe for EMSA?

Pannapa Pinweha @Pannapa_Pinweha

05 May 2015 1 4K Report

I have tried to search this recipe for a long time if anybody known it.

Please inform me. Thank you so much.

Maureen Lynch

You might want to check these references-

http://llinaslab.psu.edu/wp-content/uploads/2013/12/EMSA_protocol_FINAL.pdf

http://www.bio-protocol.org/pdf/20141207104541698/300%20The%20Protocol%20of%20Electrophoretic%20Mobility%20Shift%20Assay%20%28EMSA%29%20from%20Primary%20Neuron.pdf

http://www.protocol-online.org/prot/Protocols/Aimee-s-non-Radioactive-EMSA-Protocol-3455.html

Badges
Science method

More Pannapa Pinweha's questions See All

How can I improve the yield of DNA from gel purification?

Dear all, I've try to purify the digested plasmid (16 kb) from the agarose gel using the gel purification kit. Anyway, I got very low concentration of the plasmid after purification. And I cannot...

10 November 2017 2,814 1 View

How can I identify the binding sites of miRNAs?

Hi everyone I did the 25 bp deletion as series in my 3'UTR region for observing which regions are important for miRNA regulation. Now I got the region that may be regulated by miRNAs but I don't...

01 February 2017 5,953 4 View

Can I use the Lipefectamine-2000 for mimic miRNA transfection?

I would like to transfect the mimic miRNA into the cells. And I have some questions. 1. Is the Lipofectamine 2000 suitable for mimic miRNA transfection? 2. Does anybody has the experience in...

11 December 2015 9,017 8 View

Can I use the SYBR green to detect U6 snRNA during qPCR of miRNA detection?

I would like to measure miRNA expression by stem-loop RT PCR. I case of normalizer, I would like to use U6 snRNA by using SYBR green system. That's it possible.

09 October 2015 4,642 8 View

What is the effect of low ct value of 18srRNA on qPCR reaction?

Hi everyone, I would like to know that if my normalized gene " 18srRNA" was detected at ct=9 but my interested gene was detected at ct=29, I would like to know that why is the low ct not good for...

09 October 2015 7,095 3 View

How can I check the cDNA after performing stem loop RT-PCR?

I would like to check the cDNA after the stem loop RT-PCR reaction done. In the normal RT-PCR, the cDNA can check by B-actin amplification. But stem loop RT-PCR is different. So can anyone tell...

09 October 2015 5,906 5 View

How to calculate CCS for Sodiated adduct ions and Multiply Charged Ions?

I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...

08 August 2024 8,329 0 View

AMAXA Lonza nucleofection lower volume of buffer?

Does anyone tried to do nucleofection with AMAXA by Lonza with lower than recommended amount of buffer in the cuvettes (100 ul)?

07 August 2024 4,616 0 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

Why activated CAR-Jurkat cell could not kill targets?

Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...

06 August 2024 641 2 View

Why I can't see any band in SDS-PAGE?

Currently, when I run SDS-PAGE, I don't see any bands at all, even though I used the same material just a day ago and it worked fine.... In our lab, we dilute the 10X running buffer to 1X and...

06 August 2024 5,373 2 View

Why might the impedance values for DI water and 0.1X PBS buffer solution exhibit a decreasing and increasing trend, respectively over time (HP 4194A)?

Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...

05 August 2024 3,783 2 View

How to isolate lymphocytes from mouse spleen?

I have tried several times to isolate lymphocytes from mouse spleen, but all attempts have been unsuccessful. I tried most available protocols. I used different dissociation media (HBSS with Ca...

04 August 2024 9,913 7 View

How to use Density Functional Theory to calculate carrier mobilities of solid system?

Hello, everyone. I have tried to determine carrier motilities of some materials, by Density Functional Theory, using Quantum ESPRESSO. There are a few methods to do it, like a package called...

04 August 2024 8,894 1 View

What is the best blank for nanodrop if I want to read a recombinant protein concentration?

Is it the "elution buffer" or the "dialysis buffer"? Note: I'll be using NanoDrop OneC

01 August 2024 967 3 View

What Are the Best Alternatives to the MTT Assay for Assessing Cell Toxicity of Colored Herbal Extracts?

I am currently investigating the cytotoxicity of a series of herbal extracts, and like many studies, I have been using the MTT assay to evaluate cell viability. However, I am encountering a...

31 July 2024 193 4 View