Could native page detect tiny mobility changes?

11 November 2016 0 8K Report

My protein is 25KD and its pI is 5.5. How much concentration of my native page could be? The native page could deter the tiny mobility changes? And which is the right running buffer, 0.5*TBE or Tris-Glycine?

Thanks.

Badges
Science method

More Liming Zhang's questions See All

How to purify a special lipid, such as cholesterol and phospholipids?

How to purify a special lipid, such as cholesterol and phospholipids? I need to purify the whole cholesterol in the blood to the exclusion of other lipids. Is there any special molecules to purify...

04 May 2019 7,140 4 View

Which laptop configuration should i choose for bioinformatics?

which laptop configuration should i choose for bioinformatics? I'm going to study the bioinformatics. But, the professor told me that my laptop isn't suitable for bioinformatics. Therefore, i...

11 December 2018 7,112 0 View

Can SDS-PAGE detect monomer and polymer?

Can SDS-PAGE detect monomer and polymer? If it can, DTT should be added prior to load in gel?

05 June 2018 3,830 1 View

Which concentration of the Bis could the native page need?

The PI of two proteins are 4.96 and .4.86 and the MW of them are both roughly 15KD. Which concentration of the Bis could the native page need? How about the voltage when running？

05 June 2017 9,422 3 View

What is the white cloudy precipitation after lysing HEK-293T cells?

What is the white cloudy precipitation after lysing HEK-293T cells? My lysis buffer is composed of 1%NP-40, 150mMNaCl, 50mMTris, 5mMEDTA. After lysing 30min and centrifuge at 1,2000 *g with 30min,...

04 May 2017 469 0 View

Why CHAPS cannot solve in water after shaking?

I added 1 g CHAPS into 100ml water and shook it. However, it didn't become clear. Why? How could i do to obtain a clear 1% CHAPS?

10 November 2016 6,389 0 View

How much concentration of CHAPS can i use in lysis buffer?

How much concentration of CHAPS can i use in lysis buffer？ I would like to purify protein. But only CHAPS is compatible with mass spectrometry.

10 November 2016 6,631 3 View

Could cells from proliferation express the plasmid which i have transfected?

Could cells from proliferation express the plasmid which i have transfected using Lipofectamine2000? What about the mechanism?

08 September 2016 8,367 0 View

Could I get a high yield human protein production in MDCK?

Can I get a high yield human protein production in Madin Darby Canine Kidney(MDCK)? Which factor should be focused on if I choose a cell line to yield human protein production? Why people choose...

04 May 2016 4,670 3 View

Western Blot can not detect the expression of protein, although the green fluorescence is expressed. Why ?

Western Blot can not detect the expression of protein, although the green fluorescence is expressed. Why ? The vector is CMV promoter and the sequence is that eGFP-2A site-Myc-insert. There are...

03 April 2016 2,826 4 View

Why Do TDS and EC Increase with Larger Wastewater Volumes, While BOD and COD Decrease?

I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...

09 August 2024 9,621 0 View

Could it be a cell culture contamination?

Hello everyone! I observed in my culture (htert-RPE1 cells) an orange- red particle at the bottom of the dish. It is visible to the naked eye as a very very small red dot. Could it be a...

09 August 2024 2,824 3 View

Is there any way to quantify bacterial and fungal cells in their mixed culture?

I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...

07 August 2024 7,535 4 View

AMAXA Lonza nucleofection lower volume of buffer?

Does anyone tried to do nucleofection with AMAXA by Lonza with lower than recommended amount of buffer in the cuvettes (100 ul)?

07 August 2024 4,616 0 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

Why activated CAR-Jurkat cell could not kill targets?

Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...

06 August 2024 641 2 View

Why I can't see any band in SDS-PAGE?

Currently, when I run SDS-PAGE, I don't see any bands at all, even though I used the same material just a day ago and it worked fine.... In our lab, we dilute the 10X running buffer to 1X and...

06 August 2024 5,373 2 View

Weak DAPI staining after immunohistochemistry - how to improve?

After immunohistochemistry of previously fixed in PFA and EtOH and then frozen 20 μm sections of zebrafish brain, DAPI staining is very weak (right) compared to the same sections stained without...

05 August 2024 9,637 2 View

Why might the impedance values for DI water and 0.1X PBS buffer solution exhibit a decreasing and increasing trend, respectively over time (HP 4194A)?

Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...

05 August 2024 3,783 2 View

The Curse of Evolution and Complexity?

Brain and body mass together are positively correlated with lifespan (Hofman 1993). The duration of neural development is one of the best predictors of brain size, and conception is the best...

05 August 2024 6,247 3 View