Despite single-cell RNA, how can I characterize a new cell subtype/phenotype?

A new cell subtype was found out only during regeneration phases after a cuprizone-induced demyelination model. How can I characterize this cell? It is important to highlight that was already...

13 February 2021 1,245 1 View

How do I prepare and store insect samples for JH measurements?

I need to preserve termite samples for future quantification of juvenile hormone in their bodies. Or extract the Juvenile Hormone and keep that samples stored for future quantification. I may need...

09 February 2021 1,995 1 View

How to measure beam radius over some distance in Lumerical fdtd (Collimation evaluation)?

31 January 2021 6,354 2 View

Are there any solutions for remote eye-tracking?

Since with the pandemic it doesn't look like we are going back to the lab soon, in my lab we were looking for solutions to conduct remote webcam-based eye-tracking. I've been looking at...

31 January 2021 7,315 5 View

Can someone explain why a methyl in phentolamine mesylate presents two correlations for 13C-HSQC, around the region it should appear?

Instead of appearing one single correlation of the signal of the carbon at 20.9 ppm (#11 in the attached figure), aligned to hydrogen at 2.29 ppm, it appeared two correlations (2,32 and 2,26 ppm)....

16 January 2021 4,774 2 View

What is the best method for removing power-line interference (PLI)?

In the paper A wavelet-based method for power-line interference removal i... we propose a new method for removing PLI. This method consists in identifying the ECG and noise frequency range for...

29 December 2020 9,233 3 View

Have you done or thought about doing an article about the impact of covid 19 in your research / work area? If so, which one?

Have you done or thought about doing an article about the impact of covid 19 in your research / work area? If so, which one?

27 December 2020 3,777 12 View

How to simulate the magnetohydrodynamics (MHD) phenomena in COMSOL? What is the best way to learn how to use COMSOL?

I would like to simulate the Lorentz Force resulting from the magnetohydrodynamics (MHD) phenomenon in an ionic solution.

19 December 2020 8,278 9 View

Are there any way to make the comparison between different analysis of reliability possible?

10 December 2020 7,922 4 View

Code: JavaProp Automation for MATLAB?

Hi Mr. Waugh! I'm using your code for JavaProp Automation for MATLAB on my thesis. How can I correctly reference it? Thank you!

09 December 2020 8,316 1 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

flexibility of polymers chain

effect of double bond on the flexibility of polymers

07 April 2021 0 0 View

Formulation of polymer color flakes

I am writing to request some information for making polymer color flakes. I would appreciate the help.

17 March 2021 0 0 View

Sample dilution for quantitative analysis using ELISA?

If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis

02 March 2021 7,670 3 View

I am interested in medicinal chemistry field, which books are highly recommended to learn from?

I am at the beginner level in drug design and drug discovery, and I am interested to learn more about this field. Which books are highly recommended to start from and gives me all essential...

02 March 2021 8,437 2 View