I would like to have an updated answer to this question.
I am looking for a easy but high yield kit (Miltenyi? Qiagen? Dynabeads?)
Has anyone experience with the Miltenyi one?
Thanks
Oligo (dT) dynabeads are the best.
My lab used all the columns mentioned but non of than seemed as efficient as the Zymo mini columns. We use a very small amount of tissue for RNA extraction and the yield that we obtained from this columns double the others.
Hello Fortunato
I advise yout the mirVana kit isolation, a part to isolate miRNAs. Its performance to isolate mRNA is very good, easy and in short time.
Regards
Hello Dear,
i advise you Qiagen kit for RNA isolation is best and its easy to isolate and short time process.
Hi Priyanka,
As i understood Qiagen is good for total RNa extraction.Is any other better kit available for mRNA extraction from Qiagen whose experience you have?
Hello everyone, I am currently engaged in a doctoral project focusing on the analysis of plant-pollinator interactions in various types of areas, including natural parks, conventional...
10 December 2023 9,346 2 View
I am currently using an emotiv epoc x headset for research into SSVEP signals, and I have my stimulus program sending a marker value of 1 at the beginning of the stimulus, and a marker value of 2...
02 March 2023 1,053 0 View
Hi to everyone. Recently I received skin tissues stored in 70% ethanol upon fixation in 10% NBF that would need to be processed for paraffin embedding. The samples have been sent in dry ice,...
24 April 2022 4,767 0 View
I am looking for references on Heisenberg-Weyl algebras, namely I am interested in the action of algebra elements on some basis states, i.e. matrix elements in a certain basis.
12 November 2020 422 3 View
There is a recombinant protein of interest that they provide which I might be interested to use in phage selections.
12 February 2020 3,556 2 View
If I want to know the impact of two mutually exclusive risk factors on disease burden in my population using evidence-based PAFs and their 95% CIs, can I sum the total numbers of cases (estimates)...
03 February 2020 5,664 5 View
I am dealing with support-mediated drug delivery systems, and in particular I have some cancer cells adherent on a collagen surface. I loaded a hydrophilic drug on collagen by physisorption, then...
03 August 2019 326 4 View
I have been using FACAria II (upgraded later to III) for the last 9 years to sort from yeast, to bacteria to mammalian cells. Specially after the fluidic upgrade, I really cannot complain about...
27 November 2017 9,968 2 View
To detect human IgG and IgA from serum samples in flow cytometry.
12 March 2014 8,157 2 View
We produce in vitro recombinant antibodies for different targets. When tested in ELISA -using folded target proteins - they all specifically recognize their target, but around 25-30% of them don't...
28 July 2013 1,522 4 View
Hello, I am currently having problems with RNA extraction. I am using mouse liver (C57BL6J), and I have extracted RNA from mouse liver before. Before this experiment, my final RNA pellets were...
11 August 2024 7,082 3 View
I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...
10 August 2024 8,539 5 View
I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...
09 August 2024 9,621 0 View
Hello everyone! I observed in my culture (htert-RPE1 cells) an orange- red particle at the bottom of the dish. It is visible to the naked eye as a very very small red dot. Could it be a...
09 August 2024 2,824 3 View
I've been performing RNA extraction on cotton petiole tissue for a few months now using the method described in the following paper, a derivative of the typical hot borate method...
08 August 2024 9,882 2 View
I am currently working on LncRNA; to know the lncRNA-protein interactions I want to do RNA pull down assay, so I need to design primers with T7 promoter. I need assistance in this regard.
07 August 2024 6,622 1 View
I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...
07 August 2024 7,535 4 View
Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...
07 August 2024 8,106 4 View
Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...
06 August 2024 641 2 View
Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...
06 August 2024 1,989 3 View