Which companies in Australia sell glass bottom 96 well plates?

11 November 2017 0 8K Report

I am looking for ordinary 96 well tissue culture plates, but with glass bottom. Please help.

Badges
Science topic

More Martin Sim's questions See All

Do I need a control when testing the effects of a gene on cell survival?

I have 2 cell groups; (WT)Wild-Type (Subject)Wild-Type+Transfected Gene I expose these cells to a particular drug at different doses. I then look at calcium influx. The drug is known (has...

04 May 2019 2,357 4 View

What's the best method for meauring mammalian cell doubling rate?

I have 3 cells lines; Wild type control Wild type transfected with GFP vector Wild type transfected with GOI-GFPtag I'd like to do some general characterization on the cells, including cell...

05 June 2018 9,918 0 View

How vital is it to optimise total RNA Input for qPCR reactions?

How vital is it to optimize the RNA input for reverse transcription for subsequent qPCR reactions? The qPCR reaction mix protocol calls for 25ng of template. I've been using 100ng total RNA for...

02 March 2018 587 5 View

Can gel extracted PCR products be used as positive controls for qPCR?

I'm considering performing a PCR on my gene sets (both GOIs and house keeping genes), run the PCR products on a gel, extract them from the gel, and then measure their concentrations (using a...

02 March 2018 9,662 5 View

Are DNA standards valid for calculating qPCR Efficiency?

I have plasmid containing my gene of interest. It has been linearized, gel purified, and is at known concentration. I will use this standard to generate a standard curve for my qPCR runs, and...

02 March 2018 9,149 4 View

What are the pros and cons for using a Neural Progenitor Cell verses using a Neuroblastoma cell line?

I'm very familiar with neuroblastoma cell lines, both general culturing, and differentiating. However, I've been considering transfecting my gene of interest into a non-cancer cell line. What are...

02 March 2018 5,908 2 View

Can you simply run a PCR on RNA samples to validate no DNA contamination?

I have RNA samples that I will be using for cDNA synthesis, and analysis of expression levels. The RNA has been DNAse treated, both in column during extraction, and post column extraction...

02 March 2018 773 1 View

What is a good software application for analysing degenerating axons?

I have acquired a lot of images of my neuron's axons degenerating over time by various different insults. A lot of my data is qualitative, and I could perhaps go through all the images and count...

01 February 2018 2,276 2 View

How can you fix cells without removing media?

I grow my neurons on glass surface. Their axons so delicate that I cannot remove the media entirely. When I refeed them, I remove half the media and replace it with fresh media containing double...

01 February 2018 1,768 3 View

What concentration of Desipramine do you use to inhibit noradrenaline reuptake trasnporters?

I've added 6-OHDA to my neuronal cultures to test whether they are dopaminergic, and they do die. However, I was told that I need to also inhibit noradrenaline reuptake trasnporters as 6-OHDA is...

31 December 2017 9,903 2 View

Waters 2707 HPLC autosampler problem?

I am using a 2707 waters HPLC device. When I try to inject a sample, it says missing plate or rack. I changed the needle and calibrated its position but I still get the same problem. I even get...

02 March 2021 1,408 1 View

Should we change media after1st 6hrs after plating HUVEC bought from INVITROGEN?it's not recomended by invitrogen.Will DMSO present in stock matter?

We have HUVEC bought from Invitrogen. Cat no -C-003-5c. while first plating the cells we have bought the protocol suggests not to centrifuge the cell with media to remove the DMSO. Should we...

02 March 2021 3,713 2 View

How to normalise data on OPM package from R Studio ?

Good afternoon, I recently used OmniLog from BIOLOG for my experimentations : I tested the metabolism of different strains on 2 types of plates. I have 16 strains of 3 different groups...

02 March 2021 3,584 1 View

What thickness need for ITO to use as conductive layer?

I want to do RF sputtering of ITO on glass substrate using magnetron sputtering. what thickness do i need to make it good conductive layer to use it for PSC. Moreover, whats about thickness of...

01 March 2021 395 3 View

Glass fiber content in a gypsum board ?

Any idea on how to get the volumic ratio of glass fiber in a gypsum board ? Thank you for your help !

01 March 2021 2,501 3 View

Benefits of the 24 welled plate?

We have always used the 96 welled plate, the 48 welled plate but apparently there is much evidence on the 24 welled plate and above all its benefits.It states it is the same you would use on ELISA...

28 February 2021 1,149 1 View

Can bacterial suspension be pipetted directly onto petri dish and agar poured onto it?

Hi, recently I encountered a protocol for plating which was not the usual method I have been practicing (pour LB agar onto plate, allow it to solidify, pipette bacterial suspension onto plate,...

28 February 2021 7,292 3 View

Concrete compressive strength databases?

I am looking for datasets similar to this one: http://archive.ics.uci.edu/ml/datasets/Concrete+Compressive+Strength I am looking for concretes with different types of aggregates (Recycled,...

27 February 2021 6,801 3 View

What is the best surface to culture cells isolated from a skin biopsy?

Hello, recently I am having some difficulties with maintaining the cell culture of primary cells isolated from a skin biopsy (normal and malignant). The coating of culture plates with Matrigel (a...

26 February 2021 6,151 2 View

Difficulty in cloning of 1kb gene into vector?

I am facing difficulties in cloning a 1kb gene into a vector (pJIT163). I have my gene on interest (GOI) in pUC57 and want to clone in pJIT163 using SalI and BamHI restriction sites. I am getting...

25 February 2021 3,221 7 View