In PRIMER, is it possible to downweight certain taxa in multivariate community datasets to reflect uncertainty around identification??

I have a dataset with about 80 different species. As usual, some species are very easy to identify with certainty whereas others are more difficult, which means that I am less certain of my...

03 March 2021 8,066 4 View

How to get onecolumn document from standard IEEE ACCESS LateX template?

I have prepared a manuscript in IEEE Latex template, but for some purpose, I need to prepare a word file as well (detailed format is not required). Compared to two column .tex file, one column...

02 March 2021 1,830 3 View

Gel electrophoresis result for total RNA samples, 1.5 Agarose gel was used, How to improve the integrity of RNA?

Gel electrophoresis, RNA degradation, RNA extraction from fresh tissue

02 March 2021 5,433 5 View

How to grow E.coli on the low salt LB agar plate with 50 or 100ug/ml of Blasticidin?

Hello, I would like to ask how to grow E.coli which resists 50 or 100ug/ml of Blasticidin. I have tried many methods by using low salt Luria-Bertain(LB) agar plate. However, no colonies grow. Let...

01 March 2021 2,027 2 View

OpenBCI eeg--has anyone used them?

I'm looking to try out an off-the-shelf EEG set for some exploratory work. Curious if anyone has used the OpenBCI, and how much set-up work is required. I've heard they are more difficult to get...

01 March 2021 4,128 3 View

How to remove DCU and HOBT from my reaction?

I am doing a acid and a chiral amino alcohol reaction using DCC and HOBT in DCM or THF? Can anyone suggest me how to remove DCU and HOBT from a reaction mixture??

28 February 2021 2,153 1 View

1 nm thick MgO thin-film to be deposited on Si wafer using thermal evaporation. What will be the optimum deposition conditions?

Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.

28 February 2021 3,640 3 View

How to eliminate Steady state error from Reinforcement learning genetic algorithm code?

The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...

28 February 2021 6,560 14 View

B-mercaptoethanol (BME) protocol?

Hi everybody, I have been running a multiplex IHC which allow me to stain the same tissue with different markers (Primary Ab + Secondary conjugated Ab) (AF487, AF555, AF647). Since I would like to...

27 February 2021 5,028 2 View

What is the suitable range of Sulfur content and Viscosity of Heavy fluid Oil that used in Kiln?

What is the disadvantages of high sulfur content to the ceramic burning process? and what is the effect of outranged viscosity?

24 February 2021 8,219 2 View

No amplification data for qPCR on MxPro?

I have set up a qPCR run on MxPro with SYBR green and ROX as a reference, however, when I go to the analysis section the program seems to only collect data for the dissociation curves and not the...

25 February 2021 8,039 1 View

IF troubleshooting: looking at an intracellular protein that localizes to the cell's and how to reduce increase in signal due to cell ruffles?

I am currently trying to stain for PI3KBeta in MDA-MB-231 cells. My current issue is that 1) beta stains all over the cell and 2) there is an increase in signal at the edge of the cell and this...

24 February 2021 8,582 1 View

Troubleshooting with immunofluoresence/confocal microscope? What went wrong?

Hi guys, I have no experience and little knowledge on immunofluorescence and confocal microscopy. I tried to visualize the expression of FXR in my cells (THP-1 macrophages), yet I did not...

11 February 2021 562 6 View

Cause of slow bromophenol blue migration and smearing while running SDS PAGE?

While running gels for western blotting, I am currently getting, what seems to be, the blue dye from my sample buffer migrating more slowly in sample lanes leaving blue streaks. These transfer to...

08 February 2021 5,317 3 View

QPCR troubleshooting - what could cause an increasing ROX signal?

Hi everyone, I'm looking for some help troubleshooting a recent qPCR issue I've encountered. I am using fluorescent Taqman probes and a qPCR master mix that includes ROX as a passive reference....

08 February 2021 419 3 View

How to avoid polypyrrole deposit on counter electrode?

Hi all, Currently, I electrodeposited polypyrrole on carbon electrode but I got some problem when polypyrrole also deposited on the surface of the counter electrode. The concentration of pyrrole...

05 February 2021 2,103 3 View

No signal/bands observed on western blot for ERK signaling?

My question is regarding a western blot experiment that I am performing to observe pERK signaling by stimulation with VEGF ligand (VEGF165 and VEGF121) on MDAMB231 cells and SW620 cells (both...

30 January 2021 1,039 3 View

Problem with SDS PAGE gel: Can someone help with improper resolving of proteins?

When we cast a 10% SDS PAGE gel, the protein resolution is not sufficient and is similar to an 8% gel. We tried using a freshly prepared acrylamide from a different box, but the problem still...

30 January 2021 901 2 View

Can anyone tell me a good buffer and extraction protocol for the extraction of protein from different tissues?

I tried extracting the protein from different tissues like liver, lung, heart etc using bullet blender homogenizer and RIPA buffer and ran a western blot on the preps. But the blot showed dark...

28 January 2021 2,323 7 View

Does anybody has the biodot zx1010 manual?

25 January 2021 6,257 1 View