Is there any free software for analysis of cyclic voltmmetery curves?

I have the data of my CV and I can plot it. But I want to know if any software can help me in analysis of peaks.

09 October 2017 4,511 0 View

Which material of the tubing is suitable for organic solvents while working with peristaltic pumps?

Which material of the tubing is suitable for organic solvents (like Acetonitrile, DMSO, 1,3 Dioxalene) while working with peristaltic pumps?

01 January 1970 9,461 4 View

How to experimentally check the ionic conductivity of membrane?

I am working on redox flow battery using non-aqueous solvents and currently in the membrane selection phase.

01 January 1970 3,613 3 View

Which is the accurate experiment to check solubility of active species in an organic solvent (Acetonitrile)?

Which is the accurate experiment to check solubility of active species in an organic solvent (Acetonitrile)?

01 January 1970 8,697 0 View

What is the best experimental device to check solubility of metal complexes in organic solvent?

I need an experimental device to check solubility of active species in solvent. It is done to synthesise electrolyte.

01 January 1970 8,954 4 View

How to check wettability of the electrolyte?

My electrodes should facilitate a good wettability (degree of wetting which is the ability of a liquid to maintain contact with a solid surface). But, how to measure it experimentally?

01 January 1970 7,987 3 View

Cyclic voltmetery of redox flow cell

01 January 1970 221 3 View

Why most of the researchers used Metal Acetylacetonate as redox species for NARFB?

Most of the literature is related to use of Metal Acetylacetonate as redox species for NARFB. Is there any particular reason other than solubility?

01 January 1970 506 2 View

Simulation for Flow pattern of Redox Flow cell

My objective is to scale down the size of existing redox flow-cell. I can get experimental data of spectro-photometery & conductivity meter for flow pattern of redox flow cell. Using this...

01 January 1970 4,152 0 View

Does Napabucasin soluble in dichloromethane and in ethanol?

I need to prepare a solution of Napabucasin (inhibitor of cancer cell stemness) in dichloromethane. The drug is expensive, so maybe somebody already tried to do it. If it is soluble, what is the...

02 March 2021 9,945 3 View

Why are my bands weird in this Agarose gel?

Can someone please give me some possible things that could go wrong? Here is my recipe: 0.5g Agarose 50 mL of TAE 1x 1 uL ethyl bromide. Gel was run at 100V for 1 hour. The buffer used is also TAE.

01 March 2021 9,952 3 View

What is the state of the drug inside solid lipid nanoparticles (SLNs)?

I am a little confuse with the mechanism of solid lipid nanoparticles (SLNs). The main point of encapsulating drugs into SLNs is because some drugs have low solubility in water. Therefore, SLNs...

01 March 2021 3,703 3 View

I want to performe MALDI-TOF MS for bacterial identification, I would appreciate it if anyone can tell me the matrix solution preparation protocol ?

based on what I've studied on multiple papers, for peptide and protein identification Alpha-cyano-4-hydroxycinnamic acid (CHCA) is an appropriate matrix to use, I also know that the CHCA powder...

26 February 2021 6,799 3 View

Do you kow of any database containing data on retention time, log P and polarizability for a large number of molecules?

Hi, I am a chemistry undergraduate doing my dissertation project on HPLC. In my project, I need to predict the HPLC retention time of 20 aromatic molecules, the calibration set. To do this I will...

24 February 2021 2,602 1 View

How to seperate PEG-4000 from aqueuse phase ?

Hello everyone , Please tell me if It possible to seperat POlyethelyn glycol -4000 from an aqueuse media by other ways rather heating . I have tried salting out by electrolyte solution to...

22 February 2021 7,285 5 View

How to analyse monosaccharide compositions from soluble fiber?

I have tried to hydrolyze the sample using 2 M TFA at 100C for 24, 48 h and 120C for 2 h. From these conditions, the HPLC results showed that peaks were not separated into monosaccharide. I found...

17 February 2021 5,230 1 View

No title

Hello. I ask for help - I need to get lithium tetraborate (soluble salt) from lithium carbonate and boric acid. In literature, everything seems to be simple - mix, ignite and - it's done. But it...

16 February 2021 9,523 2 View

Is There are any idea to achieve H NMR signals for swollen compound ??

the samples are not completely soluble - just swelled the solvents that's mean the sample may be partially soluble any suggestion, please

16 February 2021 8,801 3 View

Charmm/GROMACS Residue 'ZN' not found in residue topology database?

I am trying to do some MD simulations of a protein with zinc ions. I am trying to use a charmm forcefield (I have tried 2017 and 2021) and Gromacs. I get an error when doing pdb2gmx Residue 'ZN'...

12 February 2021 9,367 2 View