What is the efficiency of an induction heating coil for heating brass?

30 January 2023 1 7K Report

Hello,

I can find on the internet that the efficiency of an induction heating coil is 35-40% for aluminum and 5-15% for copper (https://www.fabtechexpo.com/blog/2019/01/03/brazing-101-induction-heating).

But what is the efficiency of an induction heating coil for brass (roughly; for some "typical" round/helical induction coil)? I am interested in the C26000 cartridge brass (CuZn: 70% 30%).

Can anyone point me to this information?

Sincerely,

Ph.D. Pavlo Herasymenko

Pavlo Herasymenko

If anyone is also interested, ChatGPT claims that the efficiency of an induction heating coil for brass (C26000 cartridge brass) can range from 20-30% or higher.

Badges
Science topic

More Pavlo Herasymenko's questions See All

How can you explain the appearance of this second half sigmoid?

One sigmoid is clearly visible on the ITC titration curve, but half of the second sigmoid is also visible at the beginning of the curve.

16 October 2023 9,844 1 View

How is it possible to prove that usage of CSR approach leads to increasing competitiveness of a company?

Dear peers! I am running a research regarding Corporate Social Responsibility. What do you think, how it is possible to prove that usage of CSR approach leads to increasing competitiveness of a...

14 November 2020 6,692 11 View

What for is saturrated sodium chloride solution in ISO 12966-2 ?

Hi, everyone. Our lab is going to use ISO 12966-2 and 12966-4 and there is one moment in sample preparation (rapid transmethylation method under alkali-catalysed conditions) that I can't...

15 September 2020 3,404 4 View

Is there a photoionization efficiency database?

Looking for gas phase PIE curves compiled in one database. Mainly interested in 6-15eV photon energies.

17 August 2020 5,199 0 View

Is there some correlation beetween thermodynamic functins and hardness of refractory compounds ?

The problem statement is a prediction some mechaninacal properties of MC type carbides solid solutions using CALPHAD.

16 January 2020 4,922 2 View

How to deal with a mismatch in 12'' CF flanges?

My turbomolecular pump (Leybold) and vacuum chamber (Pfeiffer) have difference in knife edge diameter of ~0.5 mm. This results in a noticeable camber in the used gasket and the pressure not going...

23 September 2018 9,270 3 View

Do I need a wedge in KBr windows in my FTIR setup?

I am in the process of building a new setup and have a discussion with my colleague on the subject. We will measure several monolayers on a flat reflective surface inside a vacuum chamber with ~1...

08 August 2018 9,497 2 View

Is it possible to reveal the nature of inflation tax using the methodology of legal science?

I am working on the problem of legal nature of inflation. And It would be pretty to know your position about the nature of such phenomenon. Is there any field for legal methodology to clarify and...

02 January 2017 7,633 12 View

Multiscale modeling of steel microstructure

Hi, I'm in interested in contacts with scientists who are involved in steel microstructure multiscale simulation during thermo-mechanical treatment, namely, for severe plastic deformation (SPD)

11 January 2011 5,378 3 View

CSR, PBL: Looking for partners for cooperation within Erasmus+

Dear peers! We are looking for Erasmus + partners (KA1 or KA2) from program countries. Our fields of research are: - Corporate Social Responsibility - Project Based Learning, e-Learning,...

01 January 1970 660 5 View

Some new emerging problems on application of RL for scheduling in IoT networks?

I have seen plenty of existing works on applied Reinforcement Learning (RL) policies for optimized scheduling in IoT networks including Q-learning, DQNs, and the newer ones including PPO for...

01 August 2024 8,754 2 View

What should be the sample container for the hydrothermal reaction in a microwave reactor at 180 °C for 10 min at the heating rate of 5 °C per minute?

Suggest one of them 1. Teflon-lined stainless steel autoclave: 2. Alumina (Al2O3) ceramic container

30 July 2024 7,326 1 View

How are aPTT and PT values reduced after hemodialysis compared to before dialysis value in patients with chronic kidney disease?

I am conducting my research regarding blood coagulation in patients with CKD. I observed a reduction in post hemodialysis aPTT and PT values compared to pre hemodialysis values. But most of...

30 July 2024 3,467 0 View

What are needed modules for an IoT waterlevel monitoring system?

I want to know the modules needed for an IoT project for water level monitoring

27 July 2024 1,502 3 View

Aqua regia not heating up?

I used Aqua regia to clean Au nanoparticles in the used glassware. But for some reasons, it is not heating up upon mixing. The color did change from no color to light orange. The Au NPs on the...

25 July 2024 4,390 0 View

What is the heating temperature that I can use to deactivate enzymes in bacterial extract exopolysaccharide without loss of the bioactivity of EPS?

What is the heating temperature that I can use to deactivate enzymes in bacterial extract exopolysaccharide without loss of the bioactivity of EPS? Hi I am trying to make the purification (by TCA...

22 July 2024 5,334 6 View

Appearance of crystallization peak in heating cycle of DSC test?

For which types of polymers, the crystallization peak in heating cycle of DSC test can be observed and for which types cant? In another word, when this exothermic crystallization can be observed...

18 July 2024 348 3 View

Who wants opportunities for scientific cooperation?

Dear Colleagues, I hope this message finds you well. My name is Noor Al-Huda K. Hussein,and I am a researcher specializing in deep learning applications in genetic data analysis. I am currently...

18 July 2024 5,562 0 View

I need to know the required time for VDF heating with water for 50-80°C for PVDF Polymerization in ?

i need to know the required time

15 July 2024 4,796 2 View

Unexpected 35 kDa Band Observed During Expression and Purification of Dengue 3 NS5 RdRp Domain ?

Background: I am developing an RdRp assay for Dengue virus-3 and need to express and isolate the NS5 protein's RdRp domain (~101 kDa). My expression vector includes a GST tag followed by a 6x His...

13 July 2024 9,950 3 View