How to convert high frequency(13.56Mhz) sinusoidal AC power in to DC ?

Is it possible to use normal rectifiers in this matter since capacitances of the diodes affect at this frequency? Is there any simple way to extract DC voltage using RF power?

10 November 2019 3,275 3 View

How to do low level AC measurements accurately?

Is it possible to use the same low level DC measuring methods such as electrometers , nanovoltmeters and picoammeters for low level AC measurements? I'm using the following guide to learn about...

29 August 2019 2,857 11 View

Any supplier for FRET substrate and buffer for Angiotensin I converting enzyme assay?

30 March 2017 905 2 View

What can we predict from the peak intensity ratios of a powder XRD?

16 November 2016 9,526 14 View

Is MOF-2 stable when exposed to air ?

I have synthesized an already published procedure to get MOF-2. TGA performed for the synthesized MOF was matched with the reported data. But the PXRD results differed. PXRD was done about a month...

30 October 2016 2,045 20 View

What is involved in morphological changes of SEM images of a substance?

In the sem analysis of CaCO3 nanaoparticles, the morphology images showed spherical shaped particles but the proposed morphology for these type of nanoparticles is trigonal. I prepared the...

01 March 2021 1,960 4 View

Glass fiber content in a gypsum board ?

Any idea on how to get the volumic ratio of glass fiber in a gypsum board ? Thank you for your help !

01 March 2021 2,501 3 View

What is Flat Lens Antenna?

28 February 2021 5,433 3 View

Can impedance of antenna be less than 50 ohms?

I am simulating helix antenna in hfss, right now, giving excitation with 50 ohms port. When I see the results of Z parameter (real). It shows lower than 50 ohms. Do not understand, if it can be...

27 February 2021 4,218 7 View

How can we limit artifacts caused by rotation in fiber photometry?

We are trying to run fiber photometry experiments for long time scales, but we get these sinusoidal artifacts that come up. We think they may be caused by twisting of the fiber optic subject...

25 February 2021 568 1 View

How to properly calculate Interfacial area density in a porous domain?which are possible value for glass fiber?

I'm doing a cfx simulation of a multiphase flow in pultrusion and i set the Interfacial Area density in the heat exchange of a porous medium in this way IAD=Total fiber lateral surface of fiber...

23 February 2021 6,043 1 View

How can we add reinforced thermoplastics with granules in injection molding machine?

I need to make an injection molding machine in which short fibers are to be introduced. Short fiber length and material properties are to be determined and also the material strength are to be...

22 February 2021 4,290 1 View

Helix antenna coupling problem?

Dealing with a helix antenna, made with flexible material and not rigid like using a PCB board or wire. At the beginning of the helix is too close to the ground plane, causing coupling. How can I...

21 February 2021 4,453 3 View

Staining methods for skeletal muscle fiber typing?

does anyone know the best method to differentiate and quantify rapid fatiguing and fatigue resistant muscle fibers? the old method form the 1980's uses ATP staining which is quite labor intense?

21 February 2021 6,483 3 View

Why the storage moduli E' decrease with highr fiber volume?

Hi guys, I am facing problems to interpret a DMA results. Material: Composite Bisphenol A + curaua fiber What is being tested: the influence of fiber volume on the composites properties...

12 February 2021 174 7 View