Peptide - FAQS.TIPS

Zulfaquar Ahmad Arfi @Zulfaquar_Ahmad_Arfi

02 February 2012 0 10K Report

Which preparative resin or gel would be ideal to separate a peptide from the mixture of amino acids, amino acid derivatives, vitamins and organic acids?

Please suggest.

Badges
Science method

More Zulfaquar Ahmad Arfi's questions See All

Can anyone provide a good reference to support the statement of minimum value which can be taken into consideration for Antiserum titer determination?

Antierum titer determination is usually done by its serial dilution and then taking the lowest positive value in comparison to blank. People take minimum twice or thrice of blank as positive...

31 December 2014 3,537 2 View

What is good titer in the case of antibodies?

In antibody titer determination, we generally compare the signal to noise ration. I guess 2:1 or 3:1 is taken as a positive titer. Is this also referred to as good titer? Are there any references...

10 November 2014 6,291 4 View

How is it possible that polyclonal antibodies produced in a rabbit shows auto cross reactivity?

Antibodies were raised against the whole cell extract.

03 April 2014 1,544 0 View

What could be the reason that same antibodies cross react when used in the sandwich model?

To remove any doubt all other aspects were checked such as blocking buffer, plates, etc...

03 April 2014 2,415 8 View

Peptide isolation

My sample contains a peptide which is acidic in nature of very very low concentration and with not known sequence. How can I isolate it and identify it. I already used SEC and IOn exchange to...

01 February 2012 1,757 8 View

Waters 2707 HPLC autosampler problem?

I am using a 2707 waters HPLC device. When I try to inject a sample, it says missing plate or rack. I changed the needle and calibrated its position but I still get the same problem. I even get...

02 March 2021 1,408 1 View

How optimize the Size Exclusion Chromatography?

Hello! I'll do a size exclusion chromatography, but I only have an open column, and I'll perform the peptide extraction from yeast, using buffer lysis (sodium phosphate 50 mM/NaCl 30 mM/DNAse and...

01 March 2021 2,215 2 View

Precipitate after adding laemmli buffer to protein solution containing Potassium Acetate?

Hi, I am running a size exclusion chromatography experiment with a buffer containing Potassium Acetate as a salt. I analyse these fractions through SDS-PAGE. After boiling my SEC fractions in...

01 March 2021 2,622 3 View

Any research papers for extraction of nutrient deprivation on macroalgae? Analysed by HPLC-UV and GC/MS. Possibly from macroalgae genus Rhizoclonium?

I am doing my thesis on the nutrient deprivation on the macroalgae Rhizoclonium sp. I will be analysing the levels over a period of roughly 5 days by HPLC-UV and GC/MS. I will be using seawater as...

28 February 2021 6,477 1 View

Do you kow of any database containing data on retention time, log P and polarizability for a large number of molecules?

Hi, I am a chemistry undergraduate doing my dissertation project on HPLC. In my project, I need to predict the HPLC retention time of 20 aromatic molecules, the calibration set. To do this I will...

24 February 2021 2,602 1 View

Any easy method of analyzing vitamin D in foods by HPLC?

Looking for method of extracting and analyzing vitamin D in foods by HPLC

24 February 2021 7,524 7 View

What HPLC Marker(s) should be used to detect anthocyanins in a sample?

What HPLC Marker(s) or standard is used to detect and quantify anthocyanins such as Delphinidin, Cyanidin in a given sample of plant extract?

23 February 2021 1,832 4 View

HPLC baseline failure (ACN/Water)?

My baseline increases without any explanation, it is only fixed by changing the solution B, will it be the column? Reagents? Bomb? Detector? Solution A: H3PO4 0.01% IN WATER Solution B: H3PO4...

21 February 2021 5,656 3 View

Which vial septa the right one to be used for HPLC?

This is the unanswered question stored very long in my mind and till now I could not find a right answer. Google search educated me that the red surface is the PTFE material compatible to wider...

21 February 2021 546 3 View

What is the stability of 2 3-dihydroxyquinoxaline in acidic water?

I'm developing a UHPLC assay, and the fluorescent product is 2,3-dihydroxyquinoxaline. The reaction to produce this requires hydrochloric acid (about 1.2 M). Will storage in this acidic...

20 February 2021 5,820 4 View