OUT FLOE BOUNDARY CONDITIONS

05 May 2016 0 9K Report

Which one is the best outflow boundary condition for boundary layer flow on a flat plate among the number of conditions are described in the literature ?

Badges
Science topic

More Ramesh Bhoraniya's questions See All

How to simulate Boundary layer on a rotating circular cylinder ?

I am solving axisymmetric boundary layer developed on a rotating circular cylinder using Fluent code. In a model, I modeled only fluid domain which have inlet, outlet, no-slip and free-stream...

11 December 2019 4,780 5 View

Hartree parameter \beta_{H} for wedge flow ?

I am simulating flow over an inclined flat plate using fluent. I want to compare this velocity profile with the Falkner-Skan profile. 1. what will be the value of Hartree paramer ( beta ) and...

06 July 2018 6,975 0 View

How solve incompressible flow over an inclined flat-plate using fluent ?

I am simulating flow of water on a inclined flat-plate at 8-10 degree with the x-axis. The rectangular domain is generated and discretized. The inlet and outlet boundaries are normal to the...

05 June 2018 6,713 1 View

How to simulate axisymmetric boundary layer on a rotating circular cylinder using fluent ?

I want to simulate an incompressible axisymmetric boundary layer on a circular cylinder with rotating cylinder in Fluent. Thanks

10 November 2017 8,278 2 View

How one can make expansion of temporal eigenmodes computed by the solution of Eigenvalues problem ?

Actually, i would like to compute the evolution of the disturbances w.r.t. time. The eigenvalue problem solution gives behavior of the disturbances over a long period of time. How mathematically...

07 August 2017 8,681 1 View

How we can transfer velocity field and its derivatives from cylindrical coordinates to spherical coordinates ?

Hello everyone, I am simulating incompressible flow over a bluff body using Ansys Fluent. Fluent environment supports cylindrical and Cartesian coordinates. However the governing equations...

03 April 2015 8,045 4 View

Which type of compound does lamda max of 218 indicate in a uv-vis spectrum of a partially purified compound through column and TLC?

A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...

11 August 2024 9,801 2 View

Regarding LBM in Boiling?

What should be the equation for halfway bounce back boundary condition for flow field with forcing term?

08 August 2024 7,938 1 View

How can I apply boundary conditions in an orthotropic steel deck numerical model using ABAQUS software?

I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...

08 August 2024 719 0 View

Is changing the medium during the experiment overestimate the results?

I am experimenting with cancer and non-cancer cells in a 12-well plate for 4 days with a seeding density 1*10^4/well, however, I noticed that the control group growth rate slows down on D3. Should...

07 August 2024 2,283 2 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

How to determine positive-stained cells in FACS? Use isotype or unstained control?

To compare positive and negative cell populations in flow cytometry, should I compare unstained cells with antibody stained cells? Or with the isotype control? Most papers show comparison with...

06 August 2024 6,728 6 View

Why do we equate male and female arousal?

Women, on the other hand, can become physically aroused (increased blood flow in the reproductive organs) without becoming psychologically aroused even in the slightest. (Robert Weiss)

05 August 2024 9,537 2 View

Can you recommend a 96-well plate for minimal cell adherence to the wells during phagocytosis experiments?

I have been performing short phagocytosis experiments using 96-round bottom, tissue culture treated, well plates (Falcon, 353077). I culture the cells with the phagocytic cargo for 2-4hrs, wash...

04 August 2024 5,228 4 View

Why is TLC not a form of partition chromatography?

Why is TLC not a form of partition chromatography and paper chromatography not a form of absorption chromatography?

03 August 2024 7,035 3 View

PBMC infection with virus?

In my study, I intend to infect PBMCs with SARS-CoV-2. After that, I will analyze NK cells by flow cytometry to see if their phenotype changes or if they show degranulation. After the infection, I...

01 August 2024 4,403 4 View