Can anyone please help to provide information to provide node to node connectivity on the highlighted portion. I am working on ANSYS 15.0 and unable to getting the node to node connnectivity.
Hi,
"merging" is probably the technique you are looking for. See NUMMRG command.
If you want to model bonding or other types of contact, you have to define a contact layer between the different part (see Contact Technology Guide).
Regards
Have you made single part of the three bodies as shown in the snap that are attached to each other? If these three bodies are connected to each other it is better to have them as single 'part'.
In geometry modeler select all bodies and form new part. This will make the intermediate faces of connected bodies to have matching mesh. Otherwise you can create contacts between these two bodies and that way you don't have to have matching mesh.
Main menu -> Preprocessor -> Numbering Ctrls -> Merge Items
you can can merge near nodes, keypoints, etc. together by using this function in ANSYS
best regards
From ansys mechanical you can merge the nodes
Follow the following steps
Mesh -> Insert -> Node Merge
Pushpdant Jain,,
Could you please share how did you do that? I have the same problem (Node to Node connection using CONTA178 and COMBIN39).
Thank you in advance
Amin Al-Fakih In ANSYS modeller make all body as 1 body...so that while meshing node to node connectivity will be possible.
Pushpdant Jain
I am using ANSYS workbench, I have no idea how to use ANSYS modeller.
Thank you anyway
- Badges
- Science topic