Dear friend Yuosra Amer Ali

I hope this message finds you well! I wanted to share some insights on your project of creating a nano extract of propolis. It’s a fascinating endeavor, and I believe you’ll find the process quite rewarding.

To start, you’ll want to finely crush the raw propolis to increase its surface area. This step is crucial as it enhances the extraction efficiency of the beneficial compounds. Next, dissolve the crushed propolis in a suitable solvent, such as ethanol, which is known for its effectiveness in extracting the desired properties.

The next phase involves ultrasonication, where you can use ultrasonic waves to break down the propolis into nano-sized particles. Depending on the desired size, this process can take anywhere from a few minutes to a couple of hours. Once you’re satisfied with the particle size, make sure to filter the solution to eliminate any larger particles, using a fine filter or centrifugation.

Finally, if necessary, you can employ a rotary evaporator to remove the solvent, leaving behind a concentrated nano extract. Just remember to adhere to safety guidelines when handling solvents and equipment. Tailor your methods to your specific needs, especially if this is for research or consumption.

Good luck with your extraction! If you have any questions or need further assistance, feel free to reach out.

Few of my articles you may like to read:

Patent BIOFILTRATION DEVICE FOR ENHANCED REMOVAL OF MICROPLASTICS A...

Article Hierarchical Ni-Mn Double Layered/Graphene Oxide with Excell...

Chapter Synthesis Of Manganese Oxide Nanoparticles Using Similar Pro...

Best regards,

Kaushik

Kushik Chandiliya

Thank you very much for your clear answer, your enlightening approach to the application, and your prompt response. Thank you very much.