How to arrange coordinates and extract climate dataset out of MPI-ESM-MR netcdf files?

Have a nice day everyone, I'm stuck in extracting datasets out of MPI-ESM-MR netcdf files because the latitude ranges from -3*10^6 to 3*10^6 and longitude ranges -5,9*10^6 to 5,9*10^6. Plus, the...

28 February 2021 912 3 View

Why am I getting 'Infinity' and 'NaN' in my mixed-mode energy release values?

Hi everyone, I am currently running a mixed-mode simulation of a DCB using a user-defined cohesive zone model (UEL), however, the results I am getting don't make sense. I used the same UEL for...

24 February 2021 4,157 1 View

Do I need to ask permission to use pictures for my questionnaire?

I would like to use some photo from a government website for my questionnaire. But, different photo is from the different owner. So, should I just get permission from that government body or still...

23 February 2021 1,631 3 View

Is there association of SARS-CoV-2 infection rate with meteorological factors?

There are contradictory research papers about the correlation between meteorological parameters and incidence of COVID-19 in some countries worldwide. Is there correlation between the...

15 February 2021 5,806 2 View

Which material, solution and reagent are needed for HPLC technique?

Of course, there are verity of material, but i need essential material and buffers for this technique. maybe there are some condition for reagent selection that i dont know them. Thank you!

17 January 2021 2,823 13 View

How can I find surface area of a pot which its top and base diameters are 34.5 and 32 cm and its height is 32 cm?

I am measuring the crop water use (ET) by using pots and lettuce crop as plant material, all the data of daily weighted pots are ready but I want to find the surface area of each pot. Can you...

12 January 2021 2,482 4 View

How can I get surface area of a pot which its top diameter is 34.5 cm and 32 cm its base diameter and its height is 32 cm?

I am measuring the crop water use (ET) by using pots and lettuce crop as plant material, all the data of daily weighted pots are ready but I want to find the surface area of each pot. Can please...

12 January 2021 1,726 3 View

Do the freezing reduces the efficacy of the cells for the electroporation ? should i decrease the voltage for the next time?

I'm making reprogramming of MEFs experiment and I used Piggy bac, Sleeping beauty and episomal transposition systems. After electroporation i froze the cells, then i thawed the cells but there...

06 January 2021 5,467 2 View

Do you think that genetic inheritance or the environment is more influential in the development of substance abuse?

Do you think that genetic inheritance or the environment is more influential in the development of substance abuse ?

04 January 2021 1,587 3 View

What factors are contributing to the reemergence of communicable diseases previously thought to be under control?

What factors are contributing to the reemergence of communicable diseases previously thought to be under control?

02 January 2021 5,255 7 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View

Issues with Permeabilization during Flow Cytometry?

Hello Everyone. Currently I am working to characterize macrophages in the myocardium after ischemia-reperfusion injury in rats. Due to the low total cell number isolated from rat hearts I can...

01 March 2021 3,867 3 View

Why do the air flow results vary totally when adding scalar in CFD ?

Dear All, We are using Autodesk cfd to calculate the air flow in a single sided naturally ventilated room, where air flow depends only on buoyancy due to temperature difference between inside and...

25 February 2021 9,602 4 View

Unknown debris sheets observed in cell culture flasks?

Hi, We culture neural progenitor cells in T175 culture flasks coated with PLO-Laminin. We have successfully grown these cells with our protocol for months. Recently, we observed large sheets...

25 February 2021 3,443 4 View

Why anti-CD20 or other antibodies are not used to label target cells in flow cytometry t-cell cytotoxicity assay?

New to the field of cell therapy. Why fluorescent-labeled antibodies to target cell antigens are not used for determining target cell count by flow cytometry in cytotoxicity assay (eg car-t)? Cell...

21 February 2021 3,278 3 View

How to calculate time-averaged fields from Ansys CFX solver?

I would appreciate any comments on the following problem. I need to calculate mean fields (e.g. pressure, velocity and vorticity), for which I activate Trn Stats tab in CFX-Pre. However, what I...

21 February 2021 8,548 7 View

Which software is best to analyse multi-phase fluid flows ?

Hello everyone, hope all is good. I want to analyse multi-phase fluid flow through pipe, which software is best to do so ?

21 February 2021 4,230 8 View

Can anyone help with an Accurate Diffuser Expansion Loss formula for rectangular shaped diffusers in turbulent flow regime?

I have tried Idelchik's Handbook of Hydraulic Resistance 4th Edition (2007 page 300) formulas and across some range the formulas are reported valid for, the law of conservation of energy is...

20 February 2021 2,504 1 View

Oil red O protocol for flow cytometry?

18 February 2021 4,214 3 View

How to read a flow cytometry graph detailing cell cycle?

Hello everyone, When determining cells in different stages of the cell cycle, cells are stain for Brdu and Propidium Iodide. I understand how PI can be used to discriminate between G1 and S/G2...

18 February 2021 3,920 3 View