Is there any CAD tool for generating 2D open cell foams?

More Sadikbasha Shaik's questions See All

How to interface Semi conductor physics and Fluid flow physics in COMSOL?. What are the parameters to be considered while we interface them?

I am using a silicon nano wire in microfluidic channel to identify the some changes in parameters like voltage and current. but i am unable to interface them. the two physics run individually but...

10 January 2021 8,894 1 View

Is there any analytical model to asses impact of rigid projectile on monolithic deformable plate?

I am trying to select suitable element type (Solid or Shell) for impact analysis. I have tried with both solid and shell elements. The results are same for both element types up to certain impact...

08 January 2021 3,251 4 View

Why internal energy absorbed during impact is different when simulated with solid and shell elements using abaqus?

I am trying to simulate high velocity impact of rigid spherical projectile on a rectangular plate using Abaqus Dynamic Explicit. Particulars of Projectile Diameter : 12 mm Mass : 7.05g,...

04 January 2021 10,022 3 View

Can anyone suggest how to find proper OFDM MIMO Simulink model ?

I am doing my research on a communication system. I need a Simulink model with MIMO OFDM anyone of you could suggest me to find the total OFDM transmitter and OFDM receiver Simulink design model

21 December 2020 3,709 1 View

What are the challenges in Machine Learning to integrate it with Mobile Adhoc Network ?

What are the challenges in Machine Learning to integrate it with Mobile Adhoc Network

21 September 2020 3,881 5 View

How to calculate Poisson's ratio for sandwich panel?

I am simulating the compression test of the sandwich structure in Abaqus. How can I calculate? Please suggest me a method to overcome this problem. Thank you

05 July 2020 4,085 10 View

Which combining technique (MRC or SC) is better for Cooperative communication with Non-orthogonal multiple access technique?

I am using maximum ratio combing and selection combing techniques for C-NOMA. I want to compare the results for both techniques and also suggest me any other alternative combing techniques which...

27 January 2020 7,557 10 View

Network simulation for wireless sensor network?

I need to perform network simulation between wireless sensor network for my research work. Kindly suggest me which simulator is best and open source

21 January 2020 5,591 4 View

Which topic is best for research in machine learning?

i am new to machine learning,how to find out a problem for research,could you guide me plz. Thanking you.

25 September 2019 5,119 5 View

In search of IoT simulator that can be useful for simulating Lora network?

Dear Sir, i need an IoT simulator tool that can be supported for simulating LoRa network. To my knowledge, i know Simple IoT simulator but it is paid version. Thank you,

07 July 2019 7,561 3 View

How to compare two groups with only two measurements?

Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...

03 March 2021 8,796 3 View

Why does blocking with my immunogenic peptide cause nuclear fluorescence in ICC?

Hi all, I am validating a polyclonal antibody raised against human ANT4, through WB and ICC. In most of my controls, the antibody shows very little off-target binding, but when I pre-incubate the...

03 March 2021 5,999 3 View

Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence?

I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance

03 March 2021 3,568 1 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10?

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...

03 March 2021 1,401 3 View

Do we need to write protocol for a second study of a systematic review that has been registered and published?

I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...

03 March 2021 8,920 3 View

How to increase a model accuracy ?

dear community, my model is based feature extraction from non stationary signals using discrete Wavelet Transform and then using statistical features then machine learning classifiers in order to...

03 March 2021 6,994 5 View

Do I need to do linear regression before running mediation analysis using PROCESS MACRO by Hayes ?

I just wanted to check if I need to run a linear regression separately if I am using PROCESS MACRO to run mediation analysis. Thank you.

02 March 2021 4,359 3 View

Sample dilution for quantitative analysis using ELISA?

If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis

02 March 2021 7,670 3 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

Engr. Tufail

Sadikbasha Shaik Using Python, you have the capability to create lattice structures and various other structures for simulations. I've included an example of a lattice structure that I've generated, and by utilizing the scaling option, it can be transformed into micro-photogrammetric imagery. You can connect with me on WhatsApp for further assitance; https://wa.me/+923440907874

Sadikbasha Shaik

Engr. Tufail - Thank you for your response, is it possible to grade the cell geometry over the thickness?

Sadikbasha Shaik Yes, and much more. Here are the coordinates, areas, labels, and surfaces files for the Python outputs. You can use Python code in a similar domain to generate the resulting files for your project.