Is that possible to pool odds ratio and relative risk together in a meta analysis?

25 May 2020 0 7K Report

can i pool cohort and case-control together in a meta analysis of risk factor??

Badges
Science topic

More Yohannes Tekalegn Efa's questions See All

Even if it was synthesized under optimized conditions, is the band gap of the green synthesized CuO NPs outside the typical range of 1.20 - 2.62 eV?

Even when synthesized under optimized conditions, the band gap of green-synthesized CuO nanoparticles (NPs) may fall outside the typical range of 1.20 - 2.62 eV. The energy band gap of these...

12 April 2024 6,439 0 View

Can anyone help me?

I am working on BD FACSCanto II machine. When I started the machine, the fluidic start up is not successfully completed. It says failed. Can anyone give me some clue to solve the problem? Thank you!

03 February 2024 8,555 0 View

Hi, I have monthly precipitation and monthly temperature (not classified as minimum and maximum). How can I calculate SPEI index using Rstudio?

Hi, I have monthly precipitation and monthly temperature (not classified as minimum and maximum). How can I calculate SPEI index using Rstudio? I have also additional inputs like year, months and...

14 April 2023 8,672 2 View

Please send me ANSYS Mechanical APDL Fatigue analysis codes investigate outputs such as fatigue life, damage, safety factor, sensitivity and biaxalty?

Fatigue analysis on ANSYS Mechanical APDL

02 June 2021 4,393 2 View

Why ASTM 3039 standards for specimen geometry focus on the fiber orientation and why not on the materials type,composition and manufacturing method?

The ASTM 3039 suggested a preparation of composite specimen for tensile test should be as per what i attached here....like it encourages 4methods based on fiber orientation. For 0 degeree fiber...

06 February 2021 9,852 5 View

Dear all, can any one help me how to avoid primer dimer formation?

I ran PCR to amplify lpxA gene of Campylobacter so as to detect Campylobacter jejuni and Campylobacter coli. However, I faced repeated primer dimer formation but no band was formed for my target...

06 April 2020 5,800 22 View

How could I take sampling of sediment concentration from runoff collecting tank?

I was studying plot-based comparison of two treatments regarding their contribution to sediment response. the slope is also another factor going to consider in the field experiment. the plot is...

24 March 2020 5,967 3 View

Should i use random block design when assigning the treatments inside the block?

I have principally two treatments and two blocks with different slope. the total experimental and control groups are 12 plots and they have same experiemtal units. Both blocks B1 and B2 will have...

10 February 2020 295 0 View

How can soil improvers help my crops where the growing media is red ash (fine gravel)?

Soil improvers are those which are improving the soil structure and stimulates the development of a diverse and rich microbial soil life. Here, I am not using soil but red ash (fine gravel) which...

21 October 2019 9,214 4 View

Does my title fit for a phd dissertation paper?

Project Partial replacement of waste glass and ceramic as coarse aggregate to produce c-25mpa concrete

22 December 2018 6,465 1 View

How to learn more about SPSS and its Application?

I would like to learn more about SPSS and Its application especially in regards to data analysis. Please suggest me how I can learn more about it. Thank you so much.

11 August 2024 9,101 4 View

Can I base on reverse DNA sequences to perform alignment, convert to amino acids and GenBank submission?

I have reverse sequences (AB1 format), can I base on reverse DNA sequences to perform nucleotide alignment, convert nucleotides to amino acids and deposit the sequence in GenBank database?

11 August 2024 5,138 1 View

Baseline drift in HPLC? What causes this?

Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!

11 August 2024 3,770 4 View

Text-Communication from the M1 Hand Area using BCI—and then there is Elon Musk?

Willett, Shenoy et al. (2021) have developed a brain computer interface (BCI) that used neural signal collected from the hand area of the motor cortex (area M1) of a paralyzed patient. The...

10 August 2024 7,180 0 View

Has anyone applied Python in the field of textile engineering for data analysis, automation, or smart textiles?

I'm currently exploring the application of Python in textile engineering, specifically in areas like data analysis, process automation, and the development of smart textiles. I'm interested in...

10 August 2024 7,429 2 View

How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?

09 August 2024 7,718 0 View

How are iso-frequency contours plotted?

Let's say we have a standard, regular hexagonal honeycomb with a 3-arm primitive unit cell (something like the figure attached; the figure is only representative and not drawn to scale). The...

07 August 2024 1,936 1 View

How to prepare the nanoparticle treated fungal sample for Environmental SEM analysis?

A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.

07 August 2024 5,307 1 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,105 4 View

Why does my protein refolded to beta sheet during thermal denaturation analysis?

Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...

06 August 2024 1,988 3 View