If I dissolve chemicals by heating to prepare any buffer solution, then will buffer action be affected?

01 January 2015 1 9K Report

How?

no effect on buffer action if you use right buffering chemicals. but you must set the buffering pH after cooling down the buffer solution to the temperature at which you want to run your experiments.

Badges
Science method

More Amit Kumar Yadav's questions See All

How can I retrieve my solute from acidic solution?

A solute (carbonized fine particles) was initially water insoluble. I treated it with nitric acid+water (7:3) under reflux condition for 3-4 hrs and I got a brownish solution to make it soluble. I...

01 February 2015 7,588 2 View

Can the use of chemical Cryopreservants be replaced by Nanoparticles (modified with silica Coating by the Sonogel Process)?

It seems to be so. But, will further experimentation on this will be more sophisticated?

08 September 2014 1,361 8 View

Is there anyone working with polymer nanocomposites (PNCs)?

PLA - nanocomposites may be a better and bio-compatible option for food packaging material.

08 September 2014 5,665 10 View

Is there Hydrolases which hydrolyses bond between 1.galactose-galactose , 2. N-acetylgalactosamine - galactose

There is a long glycoprotien chain. I need two enzymes . 1. one end is attached with membrane and another have galactose. At galactose end another comes and forms bond. this is the bond, i want...

08 September 2014 2,945 4 View

AMAXA Lonza nucleofection lower volume of buffer?

Does anyone tried to do nucleofection with AMAXA by Lonza with lower than recommended amount of buffer in the cuvettes (100 ul)?

07 August 2024 4,616 0 View

Why I can't see any band in SDS-PAGE?

Currently, when I run SDS-PAGE, I don't see any bands at all, even though I used the same material just a day ago and it worked fine.... In our lab, we dilute the 10X running buffer to 1X and...

06 August 2024 5,373 2 View

RNA later for the preservation of RNA in fecal samples at room temperature for one day (37°C)?

I am planning to collect human fecal samples for metatranscriptomic analysis using MGI. These samples are from indigenous people living in a region with high temperatures. I will have access to a...

06 August 2024 1,367 3 View

How to understand this crystallographic phenomenon of low temperature crystals in zeolite?

During low-temperature testing, new diffraction peaks that appear could be indicative of several phenomena. In one of our tests, we observed notable new peaks around 40° and 45° in a specific...

06 August 2024 726 3 View

Why might the impedance values for DI water and 0.1X PBS buffer solution exhibit a decreasing and increasing trend, respectively over time (HP 4194A)?

Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...

05 August 2024 3,783 2 View

What is the best blank for nanodrop if I want to read a recombinant protein concentration?

Is it the "elution buffer" or the "dialysis buffer"? Note: I'll be using NanoDrop OneC

01 August 2024 967 3 View

Is it possible to improve the reforming section of the Haber-Bosch process without using air separation units?

A typical reforming section in a large-scale Haber-Bosch process (Figure 1) comprises two reactors. A mixture of methane (CH4) and steam (H2O) is fed into a primary reformer to produce syngas via...

01 August 2024 7,051 5 View

What is the best practice for resuspending cell pellets during competent cell preparation (both electro and comp)?

I'm fairly new to making homemade comp cells and have done so with some mild success. What is generally an acceptable way of resuspending comp cells during wash steps? I've been told to swirl the...

31 July 2024 8,309 0 View

What should be the sample container for the hydrothermal reaction in a microwave reactor at 180 °C for 10 min at the heating rate of 5 °C per minute?

Suggest one of them 1. Teflon-lined stainless steel autoclave: 2. Alumina (Al2O3) ceramic container

30 July 2024 7,326 1 View

EDTA buffer solution?

Hello everyone! How can i prepare EDTA buffer solution (pH 8.2) to determine GSH levels? Thank you in advance.

29 July 2024 4,374 1 View