I have the attached curve. I would like to pick y valu in x=0.5 for example. Is there any software that can do that?

More Hima Abdelkader's questions See All

I am a PhD student, a research-machine that have good results, but I have no idea how to write acceptable paper in indexed review?

A question that arises : how can I expose my first good results in an indexed review. 1- Should I call for an expert traducer that expose my results in a good English? and if yes do I have to...

02 March 2018 7,207 3 View

Is there any free software (web site) for conference management?

I am the president of organisation committee of the international conference on electrical engineering in Eloued university on December 2018. I am using easychair.org for conference management,...

02 March 2018 8,724 3 View

Pay or not to pay to participate in a scientific conference as oral or poster? same question for audience?

I participated as organisation committee member in two conferences. The first is payable the second not payable. The questions are : - Since researchers need to meet each others in conferences,...

01 February 2018 9,454 5 View

Simulation VS Fabrication, which is first ? simulate then fabricate or fabricate then simulate?

I would like to work on a perovskite based solar cell. So, which steps to do : 1- TCAD simulation then fabrication and comparing results? 2- Fabricate directly then simulate and compare...

01 February 2018 1,023 8 View

How can ten researchers write a paper of few pages? Otherwise : do I have to co-author any researcher that helped me achieve my paper?

A lot of papers are written by several researchers. That means that everyone have its own contribution or what? Or did everyone write a part of the paper? In another way my precise question is...

01 February 2018 589 6 View

CH3NH3PbI3 or CH3NH3SnI3 ? which is better?

In perovskite based solar cells, which is better to enhance conversion efficiency with less toxicity : CH3NH3PbI3 or CH3NH3SnI3.

01 January 1970 4,109 11 View

To enhance efficiency of PSC, which ETM is better : SnO2 or TiO2?

In a planar heterojunction perovskite based solar cell (PSC) we have five layers ITO/ETL/Perovskite/HTL/Ag. To enhance efficiency, which ETL is better SnO2, or TiO2? A Ga-doped SnO2 mesoporous...

01 January 1970 5,871 4 View

Which photovoltaic technology gives best efficiency?

In attached figure shown photovotaic technologies, which is the best efficient in your opinion?

01 January 1970 963 12 View

Weak DAPI staining after immunohistochemistry - how to improve?

After immunohistochemistry of previously fixed in PFA and EtOH and then frozen 20 μm sections of zebrafish brain, DAPI staining is very weak (right) compared to the same sections stained without...

05 August 2024 9,637 2 View

Dirty and clean?

Hi everyone I need a file with a dirty and clean potato image

04 August 2024 7,199 4 View

Hello, regarding Mxene 2D titanium carbide?

I fabricated Ti3C2Tx using concentrated HF 40%, I plot an XRD as attached image below.. please let to know if I obtained it or not.

02 August 2024 6,789 4 View

What is the acceptable p-value cutoff for GO enrichment analysis ?

I have an RNA-seq data that I have analysed using Limma-voom and have extracted the gene IDs, log2FC and the p-values. At p value < 0.05, I have over 10,000 DEGs, however, when I run the GO...

31 July 2024 225 2 View

How to do Mann-Whitney U test with Bonferroni corrected p-values?

Dear All, My lab primarily works on insect wing patterns. In one of the projects, my student and I have defined 19 abnormality characters on the forewing and 6 abnormality characters on the...

31 July 2024 6,464 5 View

IHC profiler in image j software. has anyone used it to quantify nuclear DAB positivity?

Dear researchers. I tried using the IHC PROFILER in image j to quantify nuclear DAB staining. I followed the instructions in the original article by "Varghese F, Bukhari AB, Malhotra R, De A...

29 July 2024 2,229 0 View

While using the IHC PROFILER plugin in image j software, to quantify the epithelial cytoplasmic DAB staining do you crop remove the stromal tissue?

My question pertaining to the DAB staining in cytoplasm of human oral squamous cell carcinoma tissue. When quantifying the epithelial cancer cells do we have to crop remove the stromal tissue?...

29 July 2024 2,682 6 View

Bonferroni correction. I have independent t-test, paired t-test and ancova conducted. Which test would require Bonferroni adjustment?

I have two groups that I test on three different tasks. I have 4 independent t-test, 6 paired t-test and 2 ANCOVA. My concern for which t-test should I conduct bonferroni correction. At the moment...

28 July 2024 7,827 6 View

Why in 2D image created by discovery studio 2021, the halogens appear as alkyl group?

In my molecule there is Chloro group at 2-position of phenyl ring, but in 2D image it appears as methyl showing no interaction.

28 July 2024 734 0 View

Standard curve of H2O2?

Hi, I need to prepare a standard curve of H2O2 to evaluate the primary products of oxidation. H2O2 I have is 35%. How do I prepare a stock of H2O2 10 microlitere. If s.o has experience, I would be...

26 July 2024 3,460 2 View