DC analysis to calculate the Noise Margin of NAND and NOR gates using HSPICE.
I am using a windows system, what software I should use for hydration shell analysis with molecular dynamics?
02 August 2024 3,143 4 View
After World War, we have seen the formation of the United Nations. The sovereign body for peacekeeping but with regards to the Russia-Ukraine war it is visible that the UN seems to be ineffective...
18 July 2024 4,674 4 View
It has been a quite long time since the Russia and Ukraine war has been going on and if we see the context of Geopolitics and International Relations we don't see a mediation between the two...
18 July 2024 6,737 4 View
Effect of heat stress on leafy vegetables
23 June 2024 5,572 3 View
I am facing continuous raster operation failures amid Hydrological Analysis. It is very rare that the software ArcGIS 3.0.1 and older versions performs the operation properly if putting DEM 5m in...
10 June 2024 1,963 0 View
"I want to determine the concentration of a series of sugar solutions. I tried to use refractometry, but the concentration is very low and the difference between the refractive index (RI) values...
29 May 2024 2,464 9 View
I was previously using the DSSAT version 4.7 in my PC. Now, I have installed the DSSAT v4.8. Whenever I am trying to simulate the experient is shows "Range chek error". This problem exist even...
13 May 2024 5,894 0 View
I am trying to model a quasi-static compression of a complex structurAl geometry. The experiment was done at 2 mm/min of loading. I am using ANSYS Explicit Dynamics. I’m also using Automatic Mass...
20 April 2024 2,934 4 View
These tests are required for research purpose. Cost for these tests and contact numbers are required
15 April 2024 7,955 1 View
Cross-linking density and swelling ratio in the reaction solvent should be provided. What does it mean? Can you explain?
21 March 2024 5,571 1 View
Dear Authors and Researchers, I'm looking for predictive technology models (PTM) for FinFET including 10nm. Unfortunately, the following webpages do not work...
14 April 2024 4,390 1 View
Hi, I'm trying to figure out the lowest off-current level using the RPI poly-Si TFT model (Level 62). From what I've done, changing the parameters in the model doesn't make the off-current figure...
22 January 2024 1,300 0 View
HSpice transient noise simulation command '.trannoise' has the following parameters: .TRANNOISE output [METHOD=MC] [SEED=val] [START=val] + [FMIN=val] [FMAX=val] [SCALE=val] +...
18 January 2024 3,193 0 View
How to draw the layout of the CNTFET-based standard quaternary inverter using Synopsys HSPICE?
11 September 2023 1,248 0 View
Piecewise Linear (PWL) Gxxx n+ n- VCR PWL(1) in+ in- + x1,y1 x2,y2 ... x100,y100 +
14 May 2023 2,531 0 View
Generation of noise is an essential part to ensure the noise tolerance in the circuits.
23 April 2023 9,462 1 View
I will paste the output log file and the netlist so that if anyone could point me the fix for the issue would be really helpful. ****Output Log*** Using:...
15 April 2023 4,437 2 View
CNTFET-based quaternary logic circuits are susceptible to noise due to various sources, such as thermal noise, shot noise, and flicker noise.
27 March 2023 374 0 View
To calculate Static Noise Margin (SNM) from Butterfly curves.
22 March 2023 6,230 1 View
Static noise margin analysis using butterfly curves has traditionally played a leading role in the sizing and optimization of SRAM cell structures.
15 March 2023 3,130 3 View