CNTFET-based quaternary logic circuits are susceptible to noise due to various sources, such as thermal noise, shot noise, and flicker noise.
I am using a windows system, what software I should use for hydration shell analysis with molecular dynamics?
02 August 2024 3,143 4 View
After World War, we have seen the formation of the United Nations. The sovereign body for peacekeeping but with regards to the Russia-Ukraine war it is visible that the UN seems to be ineffective...
18 July 2024 4,674 4 View
It has been a quite long time since the Russia and Ukraine war has been going on and if we see the context of Geopolitics and International Relations we don't see a mediation between the two...
18 July 2024 6,737 4 View
Effect of heat stress on leafy vegetables
23 June 2024 5,572 3 View
I am facing continuous raster operation failures amid Hydrological Analysis. It is very rare that the software ArcGIS 3.0.1 and older versions performs the operation properly if putting DEM 5m in...
10 June 2024 1,963 0 View
"I want to determine the concentration of a series of sugar solutions. I tried to use refractometry, but the concentration is very low and the difference between the refractive index (RI) values...
29 May 2024 2,464 9 View
I was previously using the DSSAT version 4.7 in my PC. Now, I have installed the DSSAT v4.8. Whenever I am trying to simulate the experient is shows "Range chek error". This problem exist even...
13 May 2024 5,894 0 View
I am trying to model a quasi-static compression of a complex structurAl geometry. The experiment was done at 2 mm/min of loading. I am using ANSYS Explicit Dynamics. I’m also using Automatic Mass...
20 April 2024 2,934 4 View
These tests are required for research purpose. Cost for these tests and contact numbers are required
15 April 2024 7,955 1 View
Cross-linking density and swelling ratio in the reaction solvent should be provided. What does it mean? Can you explain?
21 March 2024 5,571 1 View
Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...
06 August 2024 1,989 3 View
The threshold voltage (Vth) of a MOS device plays a crucial role for its operation. At the same time, noise is an intrinsic factor. So how noise (flicker or thermal) change with the change in...
29 July 2024 3,246 0 View
What is the thermal expansion coefficient of human muscle?
27 July 2024 7,190 0 View
// interested in the difference between floating events and short circuits.
22 July 2024 6,565 0 View
I do not know much about FTIR! The material Benzethonium Chloride USP was compared to a reference standard in regards to FTIR, as per the USP testing: Identification B. Infrared absorption (FTIR),...
16 July 2024 6,918 7 View
I want to extract glycosides from my mangrove leaf samples, but my laboratory lacks an incubator capable of reaching temperatures above 60°C. The paper I am following specifies a minimum...
13 July 2024 3,686 0 View
"When solar irradiation reaches a surface, some of it is absorbed while the rest is reflected. Part of the light absorbed by the surface transforms into heat and increases the module's...
13 July 2024 8,621 5 View
We're studying the stability and fusion behavior of multiple PVC compounds in a Brabender. After a few trials, we set the temperature at 195 °C and the rotor speed at 70 rpm. Samples differ in...
12 July 2024 2,768 1 View
Dear Members, We are conducting a research survey on the Printed Circuit Board (PCBs) industry and would greatly appreciate your valuable input. To participate, click the following...
09 July 2024 4,936 1 View
For the PDMS material, it's linear thermal expansion coefficient is about 3.2*10-4/℃. The polyimide has a smaller linear thermal expansion coefficient like 2*10-5/℃, but it cannot be stretch. It...
04 July 2024 4,525 1 View