How to read a flow cytometry graph detailing cell cycle?

Hello everyone, When determining cells in different stages of the cell cycle, cells are stain for Brdu and Propidium Iodide. I understand how PI can be used to discriminate between G1 and S/G2...

18 February 2021 3,920 3 View

How to improve NHBE adhesion after subculture?

I'm trying to subculture NHBE cells from Lonza, however, the cells seem to not adhere to the new flasks after detachment. I've followed Lonza detachment protocol (2 mL/25 cm2 of Trypsin 0.05% and...

10 February 2021 196 1 View

How to perform Potential Surface Energy Exploration (PES) calculations?

I would like to receive help, as I am trying to make an analysis of the ethanol PES, but the calculations are always giving error. I use the conda-forge version of xtb (* xtb version 6.3.2...

04 January 2021 602 2 View

How to determine Forster radius of a FRET pair?

Dear all, I'm searching for methods to calculate Forster Radii of FRET pairs, ideally for water-soluble and membrane dyes. Although I am relatively familiar with working with microscopy FRET, I am...

07 December 2020 3,051 3 View

Can an algorithm come into control and possession of data without the knowledge of or input from a human programmer?

Keeping in mind the adage on machine learning: data in, data out. I am curious whether there are neural network algorithms that could allow an algorithm to control and possess data on its own...

30 November 2020 860 11 View

What is the relationship between induction machine stator reactance variation and slip?

It is possible to notice, at some three phase induction machine datasheets, that exists a relationship between stator leakeage reactance and slip, that is, the stator leakage reactance increases...

23 November 2020 2,949 3 View

Bloodworms (Chironomus sp) mass production protocol?

Anyone knows an effective protocol to mass produce bloodworms larvae at lab?

26 October 2020 6,998 2 View

Double digestion with restriction enzymes not working. Any suggestions?

Hello there, I'm having some issues with digesting a PCR product and using it for ligation with the vector pET-28a. My PCR product is about ~1200 bp, I purify it and get about 30 ng/uL. Then I...

21 October 2020 2,736 3 View

Is there variability in dorsal glow spots in Lamprohiza mulsantii also in thoracic segments ?

I decided to edit this question to show the right/ correct things and erase those clearly wrong in order to avoid confusion....

03 October 2020 5,889 3 View

Can you have a (very) local weather forecast model with simple weather stations?

Dear metereologists, sorry if this question is too basic, I'm just curious about it So, I`ve seen some personal stations that capture temperature, humidity, wind speed and pluviometry...

27 September 2020 178 4 View

Logistical regression using SPSS for a dichotomous dependent variable, with an independent variable of 1, 2, 5 and 10 seconds?

I have an experiment with 28 participants The independent variable is the times 1, 2, 5, and 10 used as the cross hairs during a task These 4 times were tested using 4 different blocks, each...

03 March 2021 9,692 2 View

Do I need to do linear regression before running mediation analysis using PROCESS MACRO by Hayes ?

I just wanted to check if I need to run a linear regression separately if I am using PROCESS MACRO to run mediation analysis. Thank you.

02 March 2021 4,359 3 View

New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before?

Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...

02 March 2021 3,024 2 View

Which is a lucid standard comprehensive book to guide on psychological scale construction and its standardization?

02 March 2021 7,082 3 View

LOAD DISPLACEMENT CURVES Stiffness increasing in ANSYS non linear analysis. HOW CAN I CORRECT IT?

Hi. I am doing non linear FE analysis using a new material beam under flexural 2 point loading using ANSYS. I have defined a bilinear material model. The solution has converged. In results I am...

01 March 2021 9,911 3 View

How to choose ANN number of hidden layers and nodes?

Hello, Could you please share any interesting research explaining how to choose the number of hidden layers and nodes per layer in case of regression problems using ANN? Thank you, any help would...

01 March 2021 6,200 3 View

PUC19 as a transfer plasmid for lentiviral delivery?

Hello, Is it possible to use pUC19 as a transfer vector to be packed in using the second generation viral particles packaging system( pMD2.G; psPAX2 plasmids)? As far as I understand it there is...

28 February 2021 4,868 2 View

Can anyone provide the Support vector regression code structure of LIBSVM MATLAB or python ?

Please, if Gaussian Parameter optimization is possible in this code structure

28 February 2021 278 3 View

How could I take into consideration the weights of observation in a system of seemingly unrelated regressions (SUR) in rstudio?

I build a model of 4 regression equations (probit and OLS) in R studio. I need to take the weights of observations into consideration. While it is simple to do so for every regression equation,...

27 February 2021 1,233 1 View

VIF very high, but correlation is low and coefficient is significant. Which one whould I choose?

Hello. I have a question whether if my coefficients (statistically significant) would be valid when VIFs are really high. In my model, there are independent variables(IV), moderating variables...

26 February 2021 956 13 View