How to calculate equimolar dose of a sample drug relative to the standard drug?

More Zia Ul Mustafa's questions See All

How can Gamma Ray API units be converted to CPS (counts per second)?

Oil and gas companies run gamma ray tool and take readings in API units while Gamma ray is also noted in cps, so how these units can be converted into each other?

24 February 2021 7,545 2 View

Pseudo random number generator in Matlab code ?

i want to implement pseudo random number generator in matlab ...i request to every one if someone have code these PRNG share with me SplitMix Permuted Congruential Generator (PCG) Random...

14 February 2021 6,828 7 View

Structure of the residual covariance matrix in a model with multilevel within-subject factors?

Hello, I have a dataset with a three-level structure. Participants reported an outcome of interest for 3-4 aspects of an incident, and they reported 4 types of incidents (1 incident for each...

09 February 2021 4,280 3 View

What are the applicable reinforcement learning based control methods for systems that have control delay?

I am studying the experimental application of reinforcement learning (RL) based control methods. For that reason, I modeled a nonlinear system without delay and trained the RL agent. In this...

02 February 2021 7,999 3 View

Mental health of COVID-19 Patients?

We want to conduct a study on the mental health and psychological problems in COVID-19 patients and would measure it in terms of Anxiety by Beck Anxiety Inventory, Depression by Patient Health...

02 February 2021 6,401 6 View

How to get the insoluble fraction of PK digestion for mitochondria?

I am trying to check for some proteins if they are located in the inner or outer mitochondria membrane after treating the cells with a neurotoxin. I am using PK to digest the mitochondria, but I...

27 January 2021 5,145 2 View

Which are the appropriate solvents for n-hexane plant extract for in vivo animal models to avoid toxicity?n-hexane plant extract is not soluble?

My n hexane plant extract is not soluble in any solvent. I have tried water, normal saline, tween 20 (2%, 5%, 10%, 50%), tween 80 (2%, 5%, 10%, 50%), pure DMSO, ethanol (2%, 5%, 10%, 50%, 97%),...

16 January 2021 3,547 3 View

Two antennas at transmitter and receiver both. How to limit signals such that each antenna at receiver get signal from only one antenna?

If I have two antennas at transmitter called T1 and T2 and signals are simultaneously transmitted from both antennas at same frequency towards two antennas at the receiver called r1 and r2. Is it...

16 January 2021 4,765 3 View

How can I produce Alpha-monopropionin and Alpha-monobutyrin in lab scale?

I understand that glycerol should be reacted with propaoiocic acid to produce monopropionin and with butyric acid to produce monobutyrin , if you can help with the reaction conditions based on 1...

13 January 2021 1,151 4 View

How much Morphine Standard is dire need for determination and extraction of Morphine in HPLC technique?

I want to purchase some Morphine Standard for HPLC to detect Morphine rate in Papaver somniferum L. how much is need in every stage or phase?

08 January 2021 1,675 3 View

How to repeat an operation on an atom selection for multiple times in PyMol?

Hi, I am trying to construct a multi-layer fibril structure from a single layer in PyMol by translating the layer along the fibril axis. For now, I am able to use the Translate command in PyMol...

02 March 2021 4,569 4 View

What analysis to choose with a large neste dataset and clearly skewed or kurtotic distributions?

Hello! I have a dataset of n=3000 nested within 8 countries with approximately 200 or 400 responses in each country. I originally planned to perform multilevel modelling with 4 dependent variables...

02 March 2021 6,865 1 View

What is the state of the drug inside solid lipid nanoparticles (SLNs)?

I am a little confuse with the mechanism of solid lipid nanoparticles (SLNs). The main point of encapsulating drugs into SLNs is because some drugs have low solubility in water. Therefore, SLNs...

01 March 2021 3,703 3 View

How does an antibody have full intact antibody + half antibody?

Hello, I was just wondering how does a antibody have full intact antibody + half antibody? Is it because of the drug conjugation?

28 February 2021 1,577 1 View

Is there a method of determining feed digestibility without the need to re-pellet the feed?

I am aiming to determine the ADC values of a commercial fish feed, but I do not have a steam pelleter or extruder available to me. Ideally, the pellets could be coated with some inert marker....

28 February 2021 7,967 3 View

Can Ethovision store the generated data and video recordings directly to NAS system?

The size of data generated by Ethovision is huge. Having NAS system for data storage seems to be a good option, I am wondering whether Ethovision can directly store the data to the NAS system...

27 February 2021 6,350 2 View

How to plot the probability paper of Gumbel distribution using R programing?

In R-studio, there are many commands of Gumbel package. Arguments are also different. I`m asking about the alpha parameter of the Copula which must be greater than 1. If this is the one used to...

25 February 2021 5,229 3 View

How do I choose contrasts in SPM8?

I am learning how to use SPM for PET and PET-MR analysis, but I haven't found any great resources that explain how contrasts work. I have a series of PET images where our hypothesis argues that...

24 February 2021 1,534 2 View

Experimental Design: How deal with pseudreplicates with immunological and clinical-chemical paramaeters?

Hello everybody, I am investigating the influence of a toxinon various clinical-chemical and haematological parameters in fish. I have three treatments (control, low dose, high dose) in my...

24 February 2021 1,243 1 View

Are there methods for automatically mapping floodplains, fans and terraces?

I want to map these river geoforms with as little subjectivity as possible. I have a high resolution DEM generated by drone data.

22 February 2021 7,800 3 View

Thomas Schmitt

b(Sample)=b(Standard)*M(Sample)/M(Standard)

same for:

m(Sample)=m(Standard)*M(Sample)/M(Standard)

b: Mass concentration of the solution/ m: mass of the substance

M: Molecular weight (g/mol)

Kunal Pal

Ron Hrstka

Kunal Pal, copying and pasting Thomas Schmitt's answer is not contributing anything.