How to anodized aluminium to form "white" aluminium oxide in one step?

Gedvidas Bikulcius @Gedvidas-Bikulcius

06 December 2024 1 5K Report

Hello,

... in one step means in one bath.

Regards,

Gedvidas Bikulcius

Dear Chaitanya,

You are correct about pure aluminium anodizing. Unfortunately, aluminium alloys prevail in practice.

Regards

Gedvidas

Badges
Science method

More Gedvidas Bikulcius's questions See All

What aluminum alloys are used in piston production?

Interesting and of piston production methods.

27 May 2024 1,112 3 View

At what is the lowest temperature possible with a synthetic NiS (NiS2) compouds?

Hi everyone, I am especially interested in chemical and electrochemical methods. Thanks.

02 March 2024 8,396 0 View

Where it can be used of NiP black and shiny at the same time?

The coating electrolles of NiP have properties absorbing and speculary at the same time.

21 January 2024 353 1 View

What aluminium oxide pores will absorber more light?

Let us compared Al oxide pores perpendicular to the Al substrate and parallel to each other with patirs not parallel to each other, i. e. irregularly deviated from perpendicular to the substrate....

03 January 2024 3,109 3 View

Is there a relationship between the adhesion of paint-steel obtained by scratch mesh and single scrath methods?

Hello everyone, Adhesion measurements were performed after paint-steel exposure in the NSS (neutral salt spray) chamber. P. S. On of the scratches in the paint coating was done before...

27 September 2023 7,064 0 View

Is have a correlation between the reflection of blackbody and its band-gap?

I am especially intetested inanodized and blackened aluminium and its alloys.

04 September 2023 6,382 2 View

How cold the mechanical properties of flies from divers be measured?

Hello, It is important to choose the best fly divers (source of chitin) at least qualitatively. Thanks Gedvidas

28 March 2023 3,023 1 View

How is the average coefficient of friction calculated?

Hello, It is interesting, how the average coefficient of friction iš calculated and what its physical meaning is. Sincerely, Gedvidas Bikulcius

28 February 2023 3,041 0 View

Hello everyone, Maybe someone knows how to blacken aluminium only by anodizing it?

In addition the laight reflection of the oxide layer must not exceed 5 percent. Sincerely, Gedvidas Bikulcius

23 February 2023 8,754 2 View

What methods are used to stop the rate of dissolution of magnesium (its alloy) in physiological solution?

Hello colleagues, It is known that rapid dissolution of orthopedic implants is dangerous. What methods are used to stop the rate of dissolution of magnesium (its alloy) in physiological...

29 September 2020 2,094 5 View

How to heat polymer for about 130° without oil bath ?

is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it

06 August 2024 947 1 View

Why results of ROS flurescence are negative as there was no bacteria within?

Hello. I am working on ROS production of two systems: system A is cerium oxide and hydrogen peroxide, system B is cerium oxide nanoparticle, hydrogen peroxide and potassium bromide. I did some...

04 August 2024 5,974 3 View

Why aren't most metal oxides insoluble in water?

Why BaO (s) + H2O(l) ---> Ba 2+(aq) + 2 OH - (aq) if Oxygen loves owning all the electrons, why would it bind to hydrogen which competes with Oxygen for electron ownership more so than...

03 August 2024 5,392 1 View

Why chloride turns into chlorine gas in a Downs cell?

I imagine the battery drives the graphite into a carbocation, then chloride is oxidized to donate the electron to the carbocation, but what pushes the lost electrons of chloride to be shared...

03 August 2024 5,384 0 View

How to calculate the molar proportions of the oxides from the XRF analyses?

02 August 2024 2,565 2 View

Do we save MSMEs of the Nation ?

SMEs are backbone of the country's white economy, most of them are II generation entrepreneurs and migrated from family owned business policies, and having sufficient higher educations for...

01 August 2024 5,562 2 View

What is the solubility of Iron (+3) in Bismuth Oxide?

Dear all: I am modifying Bismuth Tungstate with Hematite (Fe2O3), so I would like to know about how much Iron(+3) can form a solid solution in a Bismuth Oxide matrix. Best wishes Marco

29 July 2024 2,163 1 View

Addition of EDTA during the synthesis of copper nanoparticles to prevent it from being oxidized?

I've attempted to use this method to synthesize copper nanoparticles. Copper nanoparticles can be synthesised using a variety of precursor materials. CuSO4, distilled water, NaOH, and EDTA are...

28 July 2024 8,027 3 View

In terms of chaos, what is the necessary and sufficient condition for authoritarianism, permanent or temporary, to come to exist and persist?

Since 2016 Brexit, the world needed to change the thinking behind traditional democracy as the democratic landscape changed, yet traditional democratic thinkers and actors have been acting as if...

28 July 2024 6,515 1 View

Dear colleagues, Can anybody by chance have pdfs of two books in Chinese: Liu (2003) and Zhang et al. (2004)?

Liu Zhaosheng. 2003. Triassic and Jurassic sporopollen assemblage from the Kuqa Depression，Tarim Basin of Xinjiang，NW China. Palaeontologia Sinica， New Series A，no. 14（Whole no. 190）....

28 July 2024 6,390 1 View