How to add velocity gradient term in each of the momentum equations ?

Bagadi Ramana Murthy @Bagadi-Ramana-Murthy

09 July 2022 1 450 Report

ρ∂u/∂t+ρ(u.∇)=∇.[-pI+K]+F

I need to add -∂/∂_x (ρU_0 u_j ) this term in all three coordinates instead of F

There are many articles on the Web and books published on the Navier-Stokes equation and the various methods of solution. The velocity gradient and momentum terms are well documented.

Badges
Science topic

More Bagadi Ramana Murthy's questions See All

Why Negative peak eluted in HPLC analysis?

I'facing problem while doing HPLC analysis due to negative peak was eluted which was corresponding to the principle peak RT. I tried to remove, with different solvents, but no use. i want to know...

26 November 2020 1,960 5 View

Electric field inside a biased N-type uniformly doped semiconductor?

What does the profile of electric field look like in a uniformly doped N-type semiconductor when an external voltage of 'V' volt is applied? Please provide any reference material if possible.

06 November 2020 1,987 8 View

Is there any list available of GRAS (generally recognized as safe) microorganisms with proper references?

02 March 2020 1,011 2 View

Which stain is used to see the deposition of oil or oil glands in anatomy section of leaf(transverse section) in cymbopogon?

Cymbopogon is an aromatic grass which produces essential oils as a secondary metabolite so to see the deposition of oil in leaves transverse section of intra and inter species can you suggest me...

28 August 2019 9,357 2 View

What is the difference between lithium ion and lithium polymer battery?

Lithium ion and lithium polymer battery charging and discharging profile was found to be same. Then what is the major difference between both battery?

07 July 2019 9,301 4 View

Homing Receptors for tumor infiltrating T cells?

I am researching how different culture and expansion conditions contribute to a T cell's infiltration of a solid tumor. Was wondering what the best surface / intracellular receptors or ligands are...

26 June 2019 5,072 0 View

What are my THP-1 cells contaminated with?

Hello everyone, I recently thawed THP-1 cells, which were frozen at passage 12 in 2016. I got the cells back to culture in RPMI + 10% FCS + 1% HEPES + 1% PenStrep. The cells seemed to recover...

19 June 2019 7,802 6 View

Temperature rise in unloaded solar cell?

Im doing research on temperature rise in solar cell during open circuit condition or partially loaded. Im sure that when solar cell is in open circuit the energy generated will be transferred as...

04 January 2019 9,904 9 View

Can anyone refer me list of terpene and terpenoid with their Rf values?

I am doing tlc of cymbopogon martini leaves extract (methanol chloroform and Ethyl acetate extract ) can anyone suggest me papers for identifying compounds (terpenoid compounds) with their rf values

17 December 2018 2,817 3 View

Hiii every one i tried many time but my pcr negative control is contamination?

I changed new primers and water and anealing temperature but i didn't get results?

11 September 2018 3,512 3 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View

Issues with Permeabilization during Flow Cytometry?

Hello Everyone. Currently I am working to characterize macrophages in the myocardium after ischemia-reperfusion injury in rats. Due to the low total cell number isolated from rat hearts I can...

01 March 2021 3,867 3 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

Why do the air flow results vary totally when adding scalar in CFD ?

Dear All, We are using Autodesk cfd to calculate the air flow in a single sided naturally ventilated room, where air flow depends only on buoyancy due to temperature difference between inside and...

25 February 2021 9,602 4 View

Unknown debris sheets observed in cell culture flasks?

Hi, We culture neural progenitor cells in T175 culture flasks coated with PLO-Laminin. We have successfully grown these cells with our protocol for months. Recently, we observed large sheets...

25 February 2021 3,443 4 View

Why anti-CD20 or other antibodies are not used to label target cells in flow cytometry t-cell cytotoxicity assay?

New to the field of cell therapy. Why fluorescent-labeled antibodies to target cell antigens are not used for determining target cell count by flow cytometry in cytotoxicity assay (eg car-t)? Cell...

21 February 2021 3,278 3 View

How to calculate time-averaged fields from Ansys CFX solver?

I would appreciate any comments on the following problem. I need to calculate mean fields (e.g. pressure, velocity and vorticity), for which I activate Trn Stats tab in CFX-Pre. However, what I...

21 February 2021 8,548 7 View

Which software is best to analyse multi-phase fluid flows ?

Hello everyone, hope all is good. I want to analyse multi-phase fluid flow through pipe, which software is best to do so ?

21 February 2021 4,230 8 View

How to call both UMAT and UEL together in Abaqus?

I have a model with bulk material (matrix) and inclusions and cohesive interface elements between both. For the bulk material, I have implemented a UMAT and for the cohesive interface elements, I...

20 February 2021 1,286 2 View

Can anyone help with an Accurate Diffuser Expansion Loss formula for rectangular shaped diffusers in turbulent flow regime?

I have tried Idelchik's Handbook of Hydraulic Resistance 4th Edition (2007 page 300) formulas and across some range the formulas are reported valid for, the law of conservation of energy is...

20 February 2021 2,504 1 View